Scribd
Upload
8 views

Scan 28 Oct 2020

Uploaded by

athulyabiju331
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
8 views

Scan 28 Oct 2020

Uploaded by

athulyabiju331
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

4

QP CODE: 191013 19101371


Reg No
Name ************

B.Sc DEGREE (CBCS) EXAMINATION, MAY 2019


Fourth Semester
Core Course PH4CRTO4- SEMICONDUCTOR PHYSICS
(Common for B.Sc Physics Model I, B.Sc Physics Model lI Applied Electronics, B.Sc Physics Model II Computer
Applications, B.Sc Physics Model Ill Electronic Equipment Maintenance)
2017 Admission onwards
CB171B41
Maximum Marks: 60 Time: 3 Hours

Part A
Answer any ten questions.

Each question carries 1 mark.

1. What is N type extrinsic semiconductor?

2. Explain Diffusion Capacitance of a PN junction.

3. What is the difference between ideal diode and real diode?

4. What is the zener voltage?

5. How does a clamper circuit affect the peak and average values of the waveform?

6. Compare the output resistances of CB and CE configurations, giving typical values

7. What is the range of values of the current gain a.

8. What is leakage current in BJT? What is the effect of temperature on its leakage current?

9. What are the three operating regions of a bipolar transistor?

10. What are the factors affecting bias variations?

11 Why op-amp input minals are designed t (+) and (-) inputs?

12. What is a modulating signal?


(10x1=10)
Part B

Answer any six questions.


Each question carries 5 marks.

13. A crystal diode having internal resistance r = 30 is used for half wave rectification. If the applied voltage v = 24 Sin

wt and load resistance RL = 400 , find (1 )ldc, Im, Ims (i) dc power output and ac power input (i) dc output voltage

(iv) efficiency of rectification

14. For a zener shunt regulator if Vz= 20 V, R=2KQ, RL= 4K0 and the input voltage varies from 44 to 80 V, find the
maximum and minimum values of zener current

15. Sketch the output waveform across a negatively biased clipper having a battery of2V when a sinusoidal wave of 10V
(Pp) is applied to the circuit (Assume the diode to be ideal).

Page 1/2 Turn Over


T6 Draw the symbols of NPN and PNP transistors. What are the functions of emitter, base and collector. Explain the

doping levels of emitter. base and colleclor


F i n d the frequency of a Hartley oscillator which uses a tank circuit with inductance cols of 10mH and 8mH. The

capacitance of the capacitor is 470pF


R=4.7K2, calculate the
18Aphase shift oscillator is designed to have a frequency 1000Hz. If it
uses equal resistors
capacity of the capacitors required for sustained sinusoidal oscillations.

19AJFET has parameters of VGs (off) equal to -20V and Ipss equal to 12mA. Plot the Transconductance curve for the

device using Vas values of OV,-5V.-10V-15V and -20V.


F i n d the voltage gain and output voltage of an inverting amplifier with Rf= 47K, R1 = 1K and input voltage = 1V. Given

supply voltage =t12V. Comment on the result.


21. A carmer wave of 80V-2000KHz signal is modulated by a 10V-1000Hz sinusoidal audio signal. Calculate its modulation

index. lower and upper side frequencies and band width.


(6x5-30)

Part C

Answer any two questions.


Each question carries 10 marks.

22 What are voltage multipliers? With circuit diagram, explain the function of doubler and trippler.

feedback. What are the


What is negative feedback? Denive the equation for the gain of the amplifier with negative
23
advantages of negative feedback?

24. Explain perfomance of a CE amplifier with neat diagram and explain the phase reversal.

the resistor values and make it


25 Draw and derive the output voltage ofa four input inverting summing amplifier. Modify
an averaging ampliier.
(2x10-20)

Page 2/2

You might also like