28

JSPM’s
RAJARSHI SHAHU COLLEGE OF ENGINEERING
TATHAWADE, PUNE-33
(An Autonomous Institute Affiliated to SavitribaiPhule Pune University,Pune)

T. Y. B. Tech (Electrical Engineering)

Semester -V
[EL3105D]: Electric and Hybrid Vehicle
Teaching Scheme: Credit Examination Scheme:
TH: 03 Hours/Week TH: 03 In Sem. Evaluation : 15 Marks
Mid Sem. Exam : 25 Marks
End Sem. Exam : 60 Marks
Total : 100Marks
Course Prerequisites: Basic Electrical and Electronics Engineering, Electrical Machines, Power
Electronics
Course Objective:
 To make students understand the need and importance of Electric, Hybrid Electric Vehicles and
Fuel cell vehicle.
 To differentiate and analyze the various energy storage devices and battery charging and
management systems.
 To impart knowledge about architecture and performance of Electric and Hybrid Vehicles.
 To classify the different drives and controls used in electric vehicles.
Course Outcome:
After successful completion of the course, students will able to:
CO1: Summarize HEVs, EVs and EV subsystems and Identify forces acting on EVs
CO2: Interpret performance and selection of energy storage systems in EVs
CO3: Analyze battery management system.
CO4: Infer history and basics of HEV and basic architecture of train drives in HEV
CO5: Identify and Analyze power electronics control in HEV
CO6: Design Electric Vehicle subsystems
Course Contents
UNIT-I Introduction to Electric Vehicle 07 Hours
Overview & History of electric vehicles, social and environmental importance of electric vehicles,
Vehicle motion and the dynamic equations for the vehicle. EV Subsystem, forces acting on when a
vehicle move, aerodynamic drag, rolling resistance and uphill resistance, power and torque to
accelerate & putting it all together, concept of drive cycle, drive cycles & energy used per km, design
of EV drive train.
UNIT-II Energy Storage System 07 Hours
Basics – types, parameters – capacity, discharge rate, state of charge, state of discharge, depth of
discharge, Technical characteristics, battery pack design, properties of batteries, introduction to energy

Dr. S. L. Chavan
BoS Chairman Dr. R. B. Joshi Dr. R. K. Jain
 29

storage requirements in hybrid and electric vehicles , battery pack development.

UNIT-III Battery Charging & Management systems 07 Hours
Introduction, charging algorithm, balancing method for battery pack charging. Battery management
system representation: - battery module, measurement unit block, battery equalization balancing unit,
MCU estimation unit, display unit, fault warning block, Thermal monitoring of battery unit.
UNIT-IV Introduction to Hybrid Electric Vehicle 07 Hours
Introduction to Hybrid Electric Vehicles: History of hybrid electric vehicles, social and environmental
importance of hybrid electric vehicles, Basic architecture of hybrid drive train and analysis series drive
train, braking Fundamentals and regenerative braking in HEVs.
UNIT-V Power Electronics Control in HEV 07 Hours
Analysis of parallel, series parallel and complex drive trains and power flow in each case. Sizing of
components for different hybrid drive train topologies, impact of modern drive-trains on energy
Supplies, fuel efficiency analysis.
UNIT-VI Design of Electric Vehicle 07 Hours
Electrical Design, BMS design of Electric Vehicle, EV Motors & Controllers – Understanding Flow,
Power & efficiency, Torque production, Speed and back emf.

Text Books:
T1. Mehrdad Ehsani, Yimin Gao, Ali Emadi, “Modern Electric, Hybrid Electric, and Fuel Cell
Vehicles: Fundamentals”, CRC Press, 2010.
T2. Iqbal Hussein, Electric and Hybrid Vehicles: Design Fundamentals, CRC Press, 2003
T3. James Larminie, John Lowry, Electric Vehicle Technology Explained, Wiley, 2003.
Reference Books:
R1. Electric Powertrain - Energy Systems, Power electronics and drives for Hybrid, electric and
fuel cell vehicles by John G. Hayes and A. Goodarzi, Wiley Publication.
R2. Sandeep Dhameja, “Electric Vehicle Battery Systems”, Newnes, 2000
.http://nptel.ac.in/courses/108103009/
p://nptel.ac.in/courses/108103009/
R3. Ehsani, M.; Gao, Y.; Emadi, A. Modern electric, hybrid electric, and fuel cell vehicles
fundamentals, theory and design. 2nd Edition.

Dr. S. L. Chavan
BoS Chairman Dr. R. B. Joshi Dr. R. K. Jain