PRODUCT DATA SHEET
Rev.1 2023
Dr. Coat RBE
Multi-Purpose Rubberized Bitumen Emulsion
Description Application
Dr.Coat RBE is a rubberized bitumen emulsion for Dr.Coat RBE may be applied by brush, broom or squeegee. It is
waterproofing and protective coating applications. Is a recommended that one or two coats should be applied depending
reinforced, bitumen emulsion. It is supplied as a single on the degree of protection required. Allow a minimum of 3
component liquid, dark brown in color, which dries to form a hours between coats under normal conditions.
black flexible coating.
Cleaning
Applications Tools and spillage may be cleaned using water or white spirit or
▪ Suitable for the treatment of concrete, asphalt, metal, paraffin.
roofing felt and other similar roofing surfaces whether
flat, sloping, or vertical. Packaging and Storage
▪ May be used as a damp- proof membrane and as a vapor Dr.Coat RBE is supplied in 15 or 20 and 200 litre units. Store
barrier. in shaded warehouses away from heat, humidity or moisture.
▪ It may also be used as a coating to protect below ground Shelf life will be 12 months.
concrete.
Standard Compliance
Characteristics
Dr.Coat RBE complies with the requirements of ASTM D1227,
▪ General waterproofing and damp proofing of concrete, Type III, Class I, and ASTM D3747, Type I and is compatible
asbestos cement sheets, roofing felts, wood with a variety of substrates. when applied at a rate of 2- 3 / m2
▪ Protection of steel work Pipes and metal. per liter.
▪ Vapor Permeable allows substrate to breathe. .
▪ Reduced chloride penetration due to hard impermeable
surfaces.
▪ Single component used as supplied and easy to apply
(no skilled labor required).
▪ Solvent free.
▪ Cold applied, no heating required.
▪ Non-slumping.
Application Procedure
Surface Preparation
All substrates must be sound, clean, dry and smooth within
reason, free from protrusions, voids honeycombs and high
spots. Presence of curing agents, paint and oil will impair
adhesion.
Priming
Priming is not normally required on good quality, well
prepared substrates.
UAE
www.dr-industries.com Page 1 of 2
[email protected]
Customer Support Tel +971 54 336 7430
Technical Data
Specific Gravity at 25°C 0.99-1.01
Appearance Dark brown / Black at dry
Drying time at 25°C 2 - 4 hours
Elasticity High Elastic
Recommended 3-5 m²/L Approx.
Coverage Capacity
Chemical Resistance
Potable water Excellent
10% Sodium Hydroxide Satisfactory
5% Sodium Sulphate Satisfactory
Moist heat (70% + 80% RH) Satisfactory
Health and Safety
As with all chemical products, care should be taken to avoid
contact with skin, eyes, mouth, and foodstuffs. Treat splashes
to eyes and skin immediately, by thorough washing with clean
water. If ingested seek medical attention
supplied in a pre-measured packing. Partial mixing should not
be allowed under any condition
We hope the information here will be helpful. It is based on data
and knowledge considered to be true and accurate, and is
offered for consideration, investigation and verification by the
user, but we do not warrant the results to be obtained. Please
read all statements, recommendations, and suggestions in
conjunction with our conditions of sale, which apply to all
goods supplied by us. No statement, recommendation, or
suggestion is intended for any use that would infringe any
patent, copyright, or other third party right
UAE
www.dr-industries.com Page 2 of 2
[email protected]
Customer Support Tel +971 54 336 7430
