Scribd
Upload
25 views3 pages

Or GATE Experiment 2

Uploaded by

nemiacatamin
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
25 views3 pages

Or GATE Experiment 2

Uploaded by

nemiacatamin
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

OR GATE

Experiment No. 2
I.OBJECTIVE:

• To be able t o see the behavior of the gate based on comparison of outputs.


• To be able to verify the characteristic of OR gate based on the data gathered.

II. MATERIALS

• Breadboard
• Connecting wires : solid wire awg # 22
• LED : 6 pcs
• Supply : 6V
• Alligator clip
• 7432 TTL IC

7432 PIN CONFIGURATION

III. PROCEDURE:

1. Interconnect the OR gate as shown below.


LED 1 LED 2 LED 3 LED 4 LED 5 LED 6

S1
S2

S3
2. Switch on the power supply. Record the data inputs and outputs on table 1.
NOTE:
LED ON- stands for high logic “ 1 ”
LED OFF- stands for low logic “ 0 ”
INPUTS OUTPUTS

S1 S2 S3 LED 1 LED 2 LED 3 LED 4 LED 5 LED 6

0 0 0 0 0 0

3. Fill up the table below to verify the OR gate truth table using inputs S1 and S2.Monitor the DATA STATUS
of LED1, LED2, LED4 and LED 5.

INPUTS OUTPUTS
S1 S2 LED 1 LED 2 LED 4 LED 5

0 0
0 1
1 0
1 1

4. Notice that the inputs Or gate are tied together. What can you say about the behavior of this gate based
on comparison of LED 4 and LED 5?
_____________________________________________________________________________________
5. The second set gates composed of OR gates 3 and 4 form 3-input OR gate. Fill up the table below to
determine the truth table.

INPUTS OUTPUTS
S1 S2 S3 LED 1 LED 2 LED 3 LED 6

0 0 0
0 0 1
0 1 0
0 1 1
1 0 0
1 0 1
1 1 0
1 1 1
6. What input signal is required to produce a high logic level at the output (LED 6)?
_____________________________________________________________________________________
7. What input signals are required to produce a low logic level signal across the output (LED 6)?
____________________________________________________________________________________
8. What rule can you formulate based on the results of steps 5, 6 and 7?
_____________________________________________________________________________________
_____________________________________________________________________________________
__________________________________________________________________________

You might also like