Scribd
Upload
36 views4 pages

Lightlas SLT Deuxv

The document provides instructions for setting up and using a LIGHTLas SLT Deux-V laser system. It describes turning on the various components, adjusting settings like magnification and energy levels, and using features such as the offset dial and test button. Safety measures like engaging the emergency switch and using the test button are also outlined.

Uploaded by

Jose Carlos Fernandes Dantas
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
36 views4 pages

Lightlas SLT Deuxv

The document provides instructions for setting up and using a LIGHTLas SLT Deux-V laser system. It describes turning on the various components, adjusting settings like magnification and energy levels, and using features such as the offset dial and test button. Safety measures like engaging the emergency switch and using the test button are also outlined.

Uploaded by

Jose Carlos Fernandes Dantas
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

LIGHTLas SLT Deux-V

SLT/YAG COMBINATION SYSTEM


with Vitreolysis

QUICK START GUIDE


LIGHTLas SLT Deux-V: QUICK START GUIDE
Setting Up
Step 1
Turn the Table ON
Lasers are powered through the
table. Make sure you turn table on
first with the on-switch.

Step 2
Adjust Table Height
Make sure the green light is ON.
Adjust the height using the UP and
DOWN arrows.

Step 3
Unlock the Emergency Switch
Turn switch counter-clockwise until it
pops out. Nothing will turn on until
switch is unlocked.

Step 4
Turn on Slit Lamp
Turn the key to turn on the Slit Lamp.
Step 5 Step 7
Press Button that says Laser Power Illumination Intensity
This turns on YAG and SLT. Machine Turn knob to graudally adjust the
will self calibrate. intensity of illumination.

Step 6 Step 8
The Boost Adjust Arm Rest Height
Press for sudden boost of illumination Turn black knob to loosen hold on
during treatment. arm rest. Adjust height for comfort
and tighten. Move arm rest to
opposite side using the hole in table,
or remove arm rest entirely.
YAG & SLT Laser Settings
9 Magnification Changer
Turn knob to desired magnification.
10 Switch from YAG to SLT Mode
11 Offset (YAG mode only)
Turn dial to adjust the offset. Make sure the dial says + FOR 9
POSTERIOR OFFSET, or - FOR ANTERIOR OFFSET. This ranges
from -500 to +500.
12 12a - YAG Energy Setting
Turn to adjust for YAG energy setting. 10
12b - SLT Energy Setting 11
15
Turn to adjust for SLT energy setting.
13 Energy Reading 16
View your adjusted parameters here. 17
18
12b 12a
14 Test Button
Fires the laser while keeping the shutter closed. Safest way to
check laser output energy. 14
13
15 Set Button
Changes the laser from Standby to Treat mode. Push once
desired parameters are set.
16 Set Pulse
Change pulses from 1, 2, or 3 pulses per laser shot.
17 Total Counter
Top shows total number of shots. Bottom shows total energy
used. Record values after procedure.
18 Reset
Resets the counter.

You might also like