Scribd
Upload
64 views

Engine - Commissioning Check Sheet

The document lists 30 check points for commissioning an engine including checking the crankshaft endplay, starter, alternator, wiring harnesses, engine mounts, oil priming, coolant level, and ensuring the radiator fan is properly centered.

Uploaded by

Karthii Aju
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
64 views

Engine - Commissioning Check Sheet

The document lists 30 check points for commissioning an engine including checking the crankshaft endplay, starter, alternator, wiring harnesses, engine mounts, oil priming, coolant level, and ensuring the radiator fan is properly centered.

Uploaded by

Karthii Aju
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Engine commissioning check points

ESN - OM926 Sandvik TH320 Maheshwari (West Bengal)


S No Check Points Present Status Remarks
1 Crankshaft endplay- Before output Drive Line fitment
2 Out put Drive Line connection (Equipment side Scope)
3 Crankshaft endplay- After output Drive Line Fitment
4 Self Starter condition / Fitment Status
5 Alternaotr condition / Fitment status
6 Alternator Belt Condition (New / Old)
7 Fan Belt Condition (New / Old)
8 ECM Status (New / Old)
9 Interface Wiring Harness Conditions and status
10 Power Harness condition and status
11 Engine Ground condition and status
12 Cabin - Warning lights illumination status (CEL & SEL)
13 Warning Hooter functioning status
14 CLS function status (New / Old)
Air Cleaner Housing condtion / Status
15
(Dents/ Rubber sealing/ Element sealing area etc)
16 Cyclonic Tubes status (Clean / chock)- Cleaning Required
Air system- Hump hoses / Elbow hoses- condition
17
(crank free, hard, damage, Puncture etc.,)- New / Old
18 Clamps condition (New / Old)
19 Air system piping supports- must be proper
20 Vent hose connection status and condition- (New / Old)
21 Vaccumme Indicator function (New / Old)
22 Air Filter elements must be new- Sealing to be checked
23 Radiator cleaning / Flushing status
24 Diesel Tank Flushing
Hoses and clamps of Cooling sytem pipes-
25
Hoses must be with new with proper clamping
26 Engine Mounting Pads- must be with new
27 Engine Oil priming- before engine start
28 Recommanded coolant to be filled.
29 Fuses / Circuit breakers in engine wiring circuits
30 Battery should be fully charged and installed
31 Radiator Fan condition- It should be center from all 4 sides
32 Engine Oil grade / Brand / Level on Dipstick

You might also like