Scribd
Upload
56 views2 pages

4th Sem. / Chemical Engg (Pulp Paper Tech) Subject:Heat Transfer Section-D

Uploaded by

mukulranag4
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
56 views2 pages

4th Sem. / Chemical Engg (Pulp Paper Tech) Subject:Heat Transfer Section-D

Uploaded by

mukulranag4
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

arrangement in multiple effect evaporators. No.

of Printed Pages : 4
Roll No. .................. 120643
Q.32 Discuss the analogy between heat transfer by
conduction and flow of electricity through ohmic 4th sem. / Chemical Engg (pulp paper tech )
resistance.
Subject :HEAT TRANSFER
SECTION-D Time : 3 Hrs. M.M. : 100
Note:Long answer type questions. Attempt any three
SECTION-A
questions out of four questions. (3x10=30)
Note:Objective type questions. All questions are
Q.33 Drive an expression for heat conduction
compulsory. (10x1=10)
through a cylinderical wall.
Q.1 Name two dimensionless numbers used in
Q.34 A small black body has a total emissive power of
convection.
4.5kw/m2 determine its surface temperature
and the wavelength of emission maximum in Q.2 Define steady state.
which range of the spectrum does the
Q.3 Write SI units of viscosity.
wavelength fall.

Q.35 (a) State and explain kirchoff's law of radiation Q.4 Write objectives of evaporation.

(b) Write note on finned tube heat exchanger. Q.5 Define reflectivity.

Q.36 Discuss construction and working principle of Q.6 Write SI unit of temperature gradient.
horizontal tube type evaporator with a neat
Q.7 Names modes of heat transfer.
diagram.
Q.8 Define density of liquid.

(60) (4) 120643 (1) 120643


Q.9 Write unit of thermal Resistance. SECTION-C

Q.10 Define heat flux. Note:Short answer type questions. Attempt any eight
questions out of ten questions. (8x5=40)
SECTION-B
Q.23 Differentiate between free and forced
Note: Very Short answer type questions. Attempt any
convention with suitable examples.
ten questions out of twelve questions(10x2=20)
Q.24 Write note on solar radiation.
Q.11 Define Arithmetic Mea Area.
Q.25 Define stanton number and peclet number.
Q.12 Discuss Radiation mode of heat transfer.
Q.26 State and explain fourier'slaw of conduction.
Q.13 Define black body.
Q.27 Sketch a shell and tube type heat exchanger.
Q.14 Write objectives of insulation.
Q.28 Write note on heat loss from a pipe.
Q.15 Define steam capacity.
Q.29 A rod of 3cm diameter and 20cm length is
Q.16 Define turbulent flow.
maintained at 100°c at one end and 10°c at the
Q.17 Write wein's displacement law equation. other end. These temperature conduction are
Q.18 What is PI theorem attained where there is heat flow rate of 6 watts.
if cylindrical surface of rod is completely
Q.19 Write two examples of natural convection.
insulated. Determine the thermal conductivity of
Q.20 Define the term overall heat transfer coefficient. the rod material.
Q.21 Define emmissivity Q.30 Write note on dettus boelter equation.
Q.22 Define unsteady state conduction. Q.31 Discuss forward and backward freeding

(2) 120643 (3) 120643

You might also like