Scribd
Upload
31 views

2009 Ford Ranger Remote Programming

The document provides instructions for resetting all remotes for a 2009 Ford Ranger and reprogramming them. It explains there are different procedures depending on the vehicle, and provides two sample procedures involving turning the ignition on and off a certain number of times within time limits and pressing buttons on the remotes to confirm programming.

Uploaded by

Scooter
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
31 views

2009 Ford Ranger Remote Programming

The document provides instructions for resetting all remotes for a 2009 Ford Ranger and reprogramming them. It explains there are different procedures depending on the vehicle, and provides two sample procedures involving turning the ignition on and off a certain number of times within time limits and pressing buttons on the remotes to confirm programming.

Uploaded by

Scooter
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

2009 Ford Ranger Remote Programming

FORD REMOTE – THIS PROCEDURE RESETS ALL REMOTES FOR THE VEHICLE. ALL
FUNCTIONING REMOTES WILL HAVE TO BE REPROGRAMMED DURING THE PROCEDURE

There are a few different procedures that will program your remotes depending on what vehicle that
you have. You can find your exact procedure in your owners manual. If you do not have your owners
manual you can try any of the procedures below until you find the one that works for your vehicles

Make sure that you don’t press the brake pedal at any time during or before the procedure.
Procedure A:
1.Close all doors, then open drivers door and press the Unlock button on driver’s door while it is open,
insert key into ignition.

2.Turn ignition from OFF to RUN 8 times within 8 seconds, with the 8th time ending in RUN. Door
locks will cycle to confirm programming mode. (if the door locks do not cycle, then it was done
incorrectly. You must start over by removing key and beginning from step 1)

(Off is the position where you can remove your key, RUN is the position just shy of starting your car.)

3.Within 10 seconds press any button on the first keyless remote to be programmed. Door locks will
cycle to confirm programming. If you only have one remote then skip to step 5.
4.Within 10 seconds, press any button on the second keyless remote. Door locks will cycle again to
confirm programming. Repeat step 4. for all other remotes.
5.Turn ignition to OFF. Locks will again cycle to indicate end of programming mode.
*If this does not work try the procedure with the door closed.

Procedure B:
1. Fasten seatbelt and close all doors
2. Turn the ignition from OFF to RUN 4 times within 3 seconds.
3. Turn the ignition OFF. The system will chime to confirm programming mode.
4. Within 10 seconds, press and hold any button on first keyless remote. The system will chime once
to confirm programming.
5. Within 10 seconds, press and hold any button on second keyless remote. System will chime once
to confirm programming.
6. Turn ignition to RUN to exit programming mode.
Please note: All steps should be performed in fairly rapid succession. If you never get the initial chime
or door lock cycle, that means the vehicle has never entered programming mode. You should remove
key from ignition, open and close the door and start over.

You might also like