Scribd
Upload
23 views

How To Configure and Pair Two HC

This document describes how to configure and pair two HC-05 Bluetooth modules with one as the slave. The slave code reads the value of a potentiometer and sends it over Bluetooth serial to control an LED or servo based on commands received serially over Bluetooth.

Uploaded by

zahra lbbague
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
23 views

How To Configure and Pair Two HC

This document describes how to configure and pair two HC-05 Bluetooth modules with one as the slave. The slave code reads the value of a potentiometer and sends it over Bluetooth serial to control an LED or servo based on commands received serially over Bluetooth.

Uploaded by

zahra lbbague
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

/* How to configure and pair two HC-05 Bluetooth Modules

* == SLAVE CODE ==
*/

#include <SoftwareSerial.h>
SoftwareSerial mySerial(8, 9); // RX, TX

#define potentiometer A0 //10k Variable Resistor


#define ledPin 2

int state = 0;
int potValue = 0;

void setup() { // put your setup code here, to run once


pinMode(potentiometer, INPUT);
pinMode(ledPin, OUTPUT);
Serial.begin(9600); //Begin serial communication with Arduino and Arduino IDE
(Serial Monitor)
mySerial.begin(9600); // Default communication rate of the Bluetooth module
delay(100);
}

void loop() {
if(mySerial.available() > 0){ // Checks whether data is comming from the
serial port
state = mySerial.read(); // Reads the data from the serial port
}
// Controlling the LED
if (state == '1') {
digitalWrite(ledPin, HIGH); // LED ON
state = 0;
}
else if (state == '0') {
digitalWrite(ledPin, LOW); // LED ON
state = 0;
}
// Reading the potentiometer
potValue = analogRead(potentiometer);
int potValueMapped = map(potValue, 0, 1023, 0, 180);
mySerial.write(potValueMapped); // Sends potValue to servo motor
delay(300);
}

You might also like