100% found this document useful (1 vote)
536 views4 pages

Bosch Dcu15 Iveco Volvo

The document provides instructions for connecting to a Bosch DCU15 ECU used in Iveco and Volvo vehicles. It details the necessary cable, lifting a pin for communication, and connecting the BOOT and CNF1 pins to specific wires.

Uploaded by

domingos
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
100% found this document useful (1 vote)
536 views4 pages

Bosch Dcu15 Iveco Volvo

The document provides instructions for connecting to a Bosch DCU15 ECU used in Iveco and Volvo vehicles. It details the necessary cable, lifting a pin for communication, and connecting the BOOT and CNF1 pins to specific wires.

Uploaded by

domingos
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

BOSCH DCU15 IVECO_VOLVO

1 BOSCH DCU15 IVECO/VOLVO

1.1 PLUGIN 0915

https://ecu.design
BOSCH DCU15 IVECO_VOLVO

1.2 CONNECTIONS

1.2.1 DIRECT CONNECTION

ATTENTION

After making all the connections, connect a stabilized power supply to the New Trasdata and make sure
that the POWER LED (red) is on.

To communicate correctly with the control unit, it is necessary to use the F32GN037C/D cable.

WIRE COLOUR DESCRIPTION


Red +12 V
Black GND
Grey BOOT
Blue CNF1

https://ecu.design
BOSCH DCU15 IVECO_VOLVO

ATTENTION

In order to communicate correctly with the ECU it is necessary to lift the pin indicated in the following
image.
Reconnect the pin before reinstalling the ECU on the vehicle.

For the RX&TX connections, it is necessary to use the F34NTF53 FLAT cable.

PIN WIRE COLOUR


19 WHITE

20 BLACK

https://ecu.design
BOSCH DCU15 IVECO_VOLVO

Connect the BOOT and CNF1 pins to the grey and blue wires of the cable F32GN037C/D .

https://ecu.design

You might also like