Scribd
Upload
21 views

10 DHCP Server

Uploaded by

shahrukh khan
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
21 views

10 DHCP Server

Uploaded by

shahrukh khan
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

DHCP Server:

A DHCP server provides network configuration parameters, such as IP addresses, to DHCP


clients. You can configure a DHCP server on an interface to provide configuration parameters to
DHCP clients on the attached network. An IPv4 DHCP client uses a broadcast rather than a
multicast address to reach the server. The DHCP client listens for messages on UDP Port 68; the
DHCP server listens for messages on UDP Port 67.
Click Device, then click the System Settings > DHCP Server link.

Click the DHCP Servers tab and configure the servers. To configure DHCP server for an interface
that is not already listed, click +. To edit an existing DHCP server, click the edit icon for the
server. To delete a server, click the trash can icon for the server.

1 | P a g e Created by Ahmad Ali E-Mail: [email protected] , Mobile: 056 430 3717


DHCP Server Tab:
Enable DHCP Server—Whether to enable the server. You can configure a server but keep it
disabled until you are ready to use it.
Interface—Select the interface on which you will provide DHCP addresses to clients. The
interface must have a static IP address; you cannot be using DHCP to obtain the interface
address if you want to run a DHCP server on the interface.
Address Pool—The range of IP addresses from lowest to highest that the server is allowed to
provide to clients that request an address. The range of IP addresses must be on the same
subnet as the selected interface and cannot include: the IP address of the interface itself, the
broadcast address, or the subnet network address. Specify the start and end address for the
pool, separated by a hyphen. For example, 192.168.1.1-192.168.1.99. Click OK.

2 | P a g e Created by Ahmad Ali E-Mail: [email protected] , Mobile: 056 430 3717


Configuration Tab:
On the Configuration tab, configure auto-configuration and global settings. DHCP auto
configuration enables the DHCP Server to provide DHCP clients with DNS server, domain name,
and WINS server information obtained from a DHCP client that is running on the specified
interface. Click Enable Auto Configuration > On if you want to use auto-configuration, and then
select the interface that is obtaining its address through DHCP in From Interface.

3 | P a g e Created by Ahmad Ali E-Mail: [email protected] , Mobile: 056 430 3717


Verification & Testing:
Go to any Local LAN PC and obtain the IP automatically through DHCP. Type ifconfig

Let’s check the DNS type cat /etc/resolv.conf

Let’s check out Internet is working

4 | P a g e Created by Ahmad Ali E-Mail: [email protected] , Mobile: 056 430 3717

You might also like