STATRON AG, Switzerland

Description: Type Revision: Doc.type: File no.:

CHARGER TPRB 0 Manual M309080-000-13.DOC

Prepared: Checked: Approved: Language: Page:

J.Hunger H.Würsch J.Hunger E 1/10

Valid for: Derived from: Replaces: Order No.: Date:

PHU MY 2.1 VIETNAM 309080 14.04.00

TECHNICAL DATA

BATTERY CHARGER

Type TPRB

KKS-No. : 27BTL10, 27BTM10

27BTQ10, 27BTR10

Project:

Plant : Phu My 2.1 Add On

Plant Type : KA13E2-2 Combined Cycle Power Plant

Rating :

Location : Vietnam

We reserve all rights in this document and in the information contained therein. Reproduction, use or
disclosure to third parties without express authority is strictly forbidden.  STATRON 2002
Statron AG · Industrie Nord · CH-5506 Mägenwil · TEL. ++41 62 887 4 887 · FAX ++41 62 887 4 888
 Page: File no.:

2/10 M309080-000-13.DOC

This side intentionally left blank

 Page: File no.:

3/10 M309080-000-13.DOC

Table of Contents

220V DC CHARGER TECHNICAL DATA .........................................................................4

Input................................................................................................................................................................. 4

Output .............................................................................................................................................................. 4

Indication and control ..................................................................................................................................... 5

Operating environment ................................................................................................................................... 5

General data .................................................................................................................................................... 6

24V DC CHARGER TECHNICAL DATA ...........................................................................7

Input................................................................................................................................................................. 7

Output .............................................................................................................................................................. 7

Indication and control ..................................................................................................................................... 8

Operating environment ................................................................................................................................... 8

General data .................................................................................................................................................... 9

 Page: File no.:

4/10 M309080-000-13.DOC

220V DC CHARGER TECHNICAL DATA

Type : : 220TPRB200

Input

AC input voltage : 3 x 400 V, +10/-15%

AC input frequency : 50 Hz. ±6%

AC input current : 73,3 A (derated to 64 A for 50°C ambient)

Nominal input power : 50,6 kVA (derated to 44,3 kVA for 50°C ambient)

Connection/Supply : Three phase, 3 wire + Earth

Output

Nominal DC voltage : 220 V

Floating voltage : 241 V
High rate voltage : 259 V
Manual voltage : up to 300 V

Static float voltage

stability : ± 1% from no load to full load with AC input
voltage variations of ±10% , frequency variations of
±6% , floating voltage and ambient temperature
+5°C - +40°C

Output ripple voltage : Max. 2% R.M.S. of nom. DC voltage without

batteries connected

Nominal output current : 200 A @ 40°C, derated to 175 A for 50°C ambient

Current limit : set at 175..180 A

Current stability : ±2% at current limit.

Battery current limit : 42 A

 Page: File no.:

5/10 M309080-000-13.DOC

Indication and control

Controls : • Rectifier ON/OFF (START/STOP) switch

• Push button HIGH DC RESET
• Key switch CHARGE SELECT
• Push button LED TEST

Meters : • DC Voltmeter Charger output/battery

• DC Ammeter Charger output
• DC Ammeter Battery current

Indications : green : • MAINS ON

• CHARGER ON
• FLOAT CHARGE

yellow : • BOOST CHARGE

• COUPLING SWITCH ON

red : • MAINS FAILURE

• CHARGER FAILURE
• HIGH DC VOLTAGE
• LOW DC VOLTAGE
• FUSE BLOWN
• OVER TEMPERATURE
• MANUAL CHARGE
• BATTERY DISCONNECTED
• CB/MCB OPEN

Operating environment

Temperature range : 0°C to +50°C

Humidity : max. 95% (non-condensing)

Altitude : 1000 m above sea level.

 Page: File no.:

6/10 M309080-000-13.DOC

General data

Protection : • Slow start circuit

• DC fuse
• High DC shut down
• Phase rotation and unbalance monitor
• Over temperature shut down

Insulation Voltage : 2000 V AC/1 min.

Insulation Resistance : > 10 Mohm at 500 V DC.

Efficiency : >95 %

Ventilation : natural convection

Standard : IEC
 Page: File no.:

7/10 M309080-000-13.DOC

24V DC CHARGER TECHNICAL DATA

Type : : 24TPRB800

Input

AC input voltage : 3 x 400 V, +10/-15%

AC input frequency : 50 Hz. ±6%

AC input current : 51,2 A (derated to 44,8 A for 50°C ambient)

Nominal input power : 35.3 kVA (derated to 30,9 kVA for 50°C ambient)

Connection/Supply : Three phase, 3 wire + Earth

Output

Nominal DC voltage : 24 V
Floating voltage : 29V
High rate voltage : 31.2 V
Manual voltage : up to 36 V

Static float voltage

stability : ± 1% from no load to full load with AC input
voltage variations of ±10% , frequency variations of
±6% , floating voltage and ambient temperature
+5°C - +40°C

Output ripple voltage : Max. 2% R.M.S. of nom. DC voltage without

batteries connected

Nominal output current : 800 A @ 40°C, derated to 700 A for 50°C ambient

Current limit : set at 700...714A

Current stability : ±2% at current limit.

Battery current limit : 135 A

 Page: File no.:

8/10 M309080-000-13.DOC

Indication and control

Controls : • Rectifier ON/OFF (START/STOP) switch

• Push button HIGH DC RESET
• Key switch CHARGE SELECT
• Push button LED TEST

Meters : • DC Voltmeter Charger output/battery

• DC Ammeter Charger output
• DC Ammeter Battery current

Indications : green : • MAINS ON

• CHARGER ON
• FLOAT CHARGE

yellow : • BOOST CHARGE

• COUPLING SWITCH ON

red : • MAINS FAILURE

• CHARGER FAILURE
• HIGH DC VOLTAGE
• LOW DC VOLTAGE
• FUSE BLOWN
• OVER TEMPERATURE
• MANUAL CHARGE
• BATTERY DISCONNECTED
• CB/MCB OPEN

Operating environment

Temperature range : 0°C to +50°C

Humidity : max. 93% (non-condensing)

Altitude : 1000 m above sea level.

 Page: File no.:

9/10 M309080-000-13.DOC

General data

Protection : • Slow start circuit

• DC fuse
• High DC shut down
• Phase rotation and unbalance monitor
• Over temperature shut down

Insulation Voltage : 2000 V AC/1 min.

Insulation Resistance : > 10 Mohm at 500 V DC.

Efficiency : >85 %

Ventilation : natural convection

Standard : IEC
 Page: File no.:

10/1 M309080-000-13.DOC
0

This side intentionally left blank