Gradient Conversion Chart - Use
Gradient Conversion Chart - Use
Manual Grade
Step 1. Step 4.
Set up you laser level with the desired axis that you Once the laser level has been placed into manual/
want to use facing the same direction that you will grade mode, press the relevant adjustment buttons
be operating. Turn on your laser level and allow it on the laser levels control panel or on the remote
to level off and begin rotating in normal horizontal control (if supplied) to tilt the laser beam down the
mode. When your laser level has started to rotate, staff to the required measurement. Please refer
locate the laser beam with your laser detector to your laser levels instruction manual for further
attached to a staff. information on the manual/grade mode feature and
its operation.
Step 2.
Using the laser levels control panel or remote Step 5.
control (if supplied), press the manual/grade mode Return the detector to the original level position on
button to deactivate the automatic levelling sensors the staff.
and place laser level into manual/grade mode.
Please refer to your laser levels instruction manual Step 6.
for further information on the manual/grade mode Dig out soil and lower the staff until the detector
feature and its operation. locates the laser beam. Repeat this step as you
move away from the laser level keeping in-line with
Step 3. the grade that you have set.
To calculate the exact measurement from this
grade chart you will need to take two
measurements based off the fall. For example, if
you required a 1 in 60 fall that equaled 1.667%
you would need to measure out 6 meters from the
laser and lower the laser detector down the staff
100 millimeters from the original horizontal level
position. Please note that the accuracy of the grade
that you want to use if based off the accuracy of Locate level
these two measurements.
Step 2.
Once you have located the level position on the
staff, enter in the required grade percentage using
the laser levels controls. Please refer to your laser
levels instruction manual for further information on Use the remote control to
creating a grade using the dial-in method.
lower the laser beam down
Step 3. the staff until the detector
Once the selected grade has been entered into shows level. Then return
the laser level and accepted that it is correct, the detector to original position.
grading process will commence. Depending on
the brand and model of laser level that you are
using, the laser level may display a visible indicator
on a digital screen or an audible tone to confirm
that the grading process is complete. Please refer
to your laser levels instruction manual for further
information on these features and operations.
Step 4.
Dig out soil and lower the staff until the detector
locates the laser beam. Repeat this step as you Dig out trench to
move away from the laser level keeping in-line with required depth
the grade that you have set.
PERCENTAGE CONVERSION CHART
Grade % (10-47) Grade % (48-85) Grade % (86-215) Grade % (220-405) Grade % (410-1000)
1 in 1000 = 0.100%