Scribd
Upload
231 views

Measuring Synchronous Generator Model Parameters

The document describes tests performed on synchronous generators to measure key parameters: 1) An open-circuit test measures how terminal voltage varies with field current to determine internal generated voltage. 2) A short-circuit test measures how armature current varies with field current, producing a linear short-circuit characteristic used to determine synchronous reactance. 3) Resistance is approximated by applying DC voltage while stationary to eliminate reactance from measurements.

Uploaded by

muhammadarsalank01
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
231 views

Measuring Synchronous Generator Model Parameters

The document describes tests performed on synchronous generators to measure key parameters: 1) An open-circuit test measures how terminal voltage varies with field current to determine internal generated voltage. 2) A short-circuit test measures how armature current varies with field current, producing a linear short-circuit characteristic used to determine synchronous reactance. 3) Resistance is approximated by applying DC voltage while stationary to eliminate reactance from measurements.

Uploaded by

muhammadarsalank01
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 21

MEASURING SYNCHRONOUS

GENERATOR MODEL
PARAMETERS
The equivalent circuit of a synchronous generator that has been
derived contains three quantities that must be determined in order to
completely describe the behavior of a real synchronous generator:
Open-circuit test of the generator

To perform this test, the generator is turned at the rated speed,


Terminals are disconnected from all loads,

Field current is set to zero.

Then the field current is gradually increased in steps, and the


terminal voltage is measured at each step.

With the terminals open, IA = 0, so EA is equal to Vphase.


It is thus possible to construct a plot of EA or Vphase versus IF.
This plot is then called open-circuit characteristic (OCC) of a
generator.

With this characteristic, it is possible to find the internal


generated voltage of the generator for any given field current.
A typical open-circuit characteristic is shown in Figure
Notice that at first the curve is almost perfectly linear, The
unsaturated iron in the frame of the synchronous machine has a
reluctance several thousand times lower than the air-gap
reluctance,

At first the resulting Flux increase is linear.

When the iron finally saturates, the reluctance of the iron


increases, and the flux increases much more slowly with an
increase in magnetomotive force.

The linear portion of an OCC is called the air-gap line of the


characteristic.
Short-circuit test.

To perform the short-circuit test,

Adjust the field current to zero again and short-circuit the terminals of the
generator through a set of ammeters.

Then the armature current lA or the line current IL is measured as the field
current is increased.

Such a plot is called a short-circuit characteristic (SCC) and is shown in


Figure
It is essentially a straight line.

To understand why this characteristic is a straight line, look at the


equivalent circuit in Figure when the terminals of the machine are
short-circuited.
Notice that when the terminals are short-circuited, the armature
current lA is given by
and its magnitude is just given by
The resulting phasor diagram is shown in Figure

The corresponding magnetic fields are shown in Figure


Since Bs almost cancels BR, the net magnetic field Bnet is very
small.

Since the net magnetic field in the machine is so small, the


machine is unsaturated, and the SCC is linear.
A plot of approximate synchronous reactance as a
function of field current is shown in Figure
The resistance can be approximated by applying a dc voltage
to the windings while the machine is stationary and measuring
the resulting current flow.

The use of dc voltage means that the reactance of the windings


will be zero during the measurement process.
The Short-Circuit Ratio

The short-circuit ratio of a generator is defined as the ratio of


the field current required for the rated voltage at open circuit
to the field current required for the rated armature current at
short circuit.

You might also like