Scribd
Upload
252 views3 pages

Manual PWM To Voltage Converter Module 0 100 To 0 10V

This PWM to voltage converter module converts PWM digital signals ranging from 0-100% duty cycle to analog voltages from 0-10V, which can interface PLC or industrial control signals. It uses an MCU and potentiometer for fine tuning the output voltage according to the PWM input duty ratio between 1-3kHz. The small module operates from 12-30V DC and has a 5% allowable error range for the PWM to voltage conversion.

Uploaded by

peterpedropaulo87
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
252 views3 pages

Manual PWM To Voltage Converter Module 0 100 To 0 10V

This PWM to voltage converter module converts PWM digital signals ranging from 0-100% duty cycle to analog voltages from 0-10V, which can interface PLC or industrial control signals. It uses an MCU and potentiometer for fine tuning the output voltage according to the PWM input duty ratio between 1-3kHz. The small module operates from 12-30V DC and has a 5% allowable error range for the PWM to voltage conversion.

Uploaded by

peterpedropaulo87
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

PWM to Voltage Converter Module 0%-100% to 0-10V PWM

Description:
1. The PWM transfer voltage module LC-LM358-PWM2V converts the PWM digital signals into 0 to 10V analog
signals.
2. It can be used as signal interface switching for PLC or other industrial control boards. The output voltage is
regulated by adjusting the duty ratio of the PWM.
The modules are small in size and easy to use in different places.

Features:
1>. MCU embedded technology
2>. Easy to operate, fine tuned by potentiometer
3>. Select the PWM signal input level range through short-circuit
4>. The module is smaller, easy to carry and use

Parameter:
1>. Work Voltage:DC 12V-30V; (> 100MA)
2>. PWM Receiver Frequency:1KHZ-3KHZ
3>. PWM signal input level range:
The peak of 4.5V to 10V level. The short cap install in ‘5V’. This level is used for normal controller or 5V MCU
The peak of 12V to 24V level, so inserted in 24V. The short cap install in ‘24V’. This level is used for normal PLC
controller
4>. Conversion range:0%-100% PWM to 0-10V
5>. Allowable error:5%

Hardware Interface:
Operation instructions:
After power on, without input signal, the output is 0V, so only input can output.

The first time when the power is on, it is best to do a calibration debugging: Input a 50% duty ratio signal to
PWM/GND and adjust the relative amplitude short cap.

The frequency is 1KHZ-3KHZ, Measured VOUT and GND with a multimeter and it will display 5V.

Adjust potentiometer to make sure display 5.00V on multimeter. This will calibrate your pulse signal to this module.

When the frequency changes, the correspondences may be offset and need to be re calibrated.
The output voltage can be adjusted by adjusting the duty ratio.
The accuracy can be controlled by adjusting the potentiometer.

1. Tested by ICStation's Outstanding Partner Robojax:


Learn More Details in the Video: https://youtu.be/dt09OkopU6c

You might also like