20.02.
2023
Dear Sir/Madam,
This document has been prepared for Bozdemir Construction about Hilti HUS3 &
HUS4 Screw Anchor products.
HILTI HUS3 screw anchor is no longer manufactured as of December 2022 and
HUS4 screw is the new version and successor of HUS3-H. Thus we recommend
HUS4 M14 as a replacement to HUS3 M14. HUS4 M14 meets & exceeds the
performance of HUS3 M14. You may find the loading data of these two anchors to
compare as below.
In addition, HUS4-A may be used with a nut and a washer to fasten steel tracks to
concrete.
HUS4 M14 (New version) Load Data:
Hilti Türkiye
Barbaros Mahallesi Çiğdem Sokak
Ağaoğlu My Office 15-A Kat:2
34746 Ataşehir | İstanbul
T 44Hilti (444 4584) | F +90 (216) 5286898 | www.hilti.com.tr 1 of 2
HUS3 M14 (Old version) Load Data:
Attachments:
1- HUS4 Technical Data Sheet
2- HUS3 Technical Data Sheet
Best Regards.
Can Acar
Hilti Turkey
Area Sales Manager
Civil Engineer
M +90-5335227753
E [email protected]
www.hilti.com.tr
Disclaimer:
This proposal is a free of charge service of HILTI .It has been established by our engineers according to the
state of the art and on the basis of the informations and documents mentioned.The calculations are only valid in
connection with HILTI products which are installed and used according to our installation guidelines. It is the
user’s duty to verify for correctness, completeness and accordance with the conditions on the construction site,
to check the information, on which the calculations are based and the calculation results for plausibility. The user
remains responsible for the results obtained with this proposal. All rights reserved. No extract either may be
reproduced or published without our permission in writing.
2 of 2