Scribd
Upload
8 views

EE Lab

This document outlines the course outcomes and experiments for an Electrical Engineering Laboratory course. The course aims to: 1) Have students conduct experiments applying Kirchhoff's Laws and network theorems to DC circuits. 2) Demonstrate the behavior of AC circuits connected to single and three phase supplies and measure power. 3) Perform experiments illustrating the BH curve of magnetic materials. 4) Calculate efficiency of single phase transformers and DC machines. It then lists 12 experiments for students to perform, covering topics like Kirchhoff's Laws, network theorems, power measurement, resonance, transformers, DC machines, and induction motors.

Uploaded by

shashishukla6849
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
8 views

EE Lab

This document outlines the course outcomes and experiments for an Electrical Engineering Laboratory course. The course aims to: 1) Have students conduct experiments applying Kirchhoff's Laws and network theorems to DC circuits. 2) Demonstrate the behavior of AC circuits connected to single and three phase supplies and measure power. 3) Perform experiments illustrating the BH curve of magnetic materials. 4) Calculate efficiency of single phase transformers and DC machines. It then lists 12 experiments for students to perform, covering topics like Kirchhoff's Laws, network theorems, power measurement, resonance, transformers, DC machines, and induction motors.

Uploaded by

shashishukla6849
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

ELECTRICAL ENGINEERING LABORATORY

LTP
002

COURSE OUTCOMES

Course Outcome (CO) Bloom’s


Knowledge
Level (KL)
At the end of this course, the students should be able to:
Conduct experiments illustrating the application of KVL/KCL and
CO 1 K3
network theorems to DC electrical circuits.
Demonstrate the behavior of AC circuits connected to single phase AC
CO 2 supply and measure power in single phase as well as three phase K4
electrical circuits.
CO 3 Perform experiment illustrating BH curve of magnetic materials. K3
CO 4 Calculate efficiency of a single phase transformer and DC machine. K4
Perform experiments on speed measurement and reversal of direction
CO 5 of three phase induction motor and Identify the type of DC and AC K4
machines based on their construction.
K1 – Remember, K2 – Understand, K3 – Apply, K4 – Analyze, K5 – Evaluate, K6 – Create

LIST OF EXPERIMENTS

Note: A minimum of ten experiments from the following should be performed.

1. Verification of Kirchhoff’s laws


2. Verification of Superposition and Thevenin Theorem.
3. Measurement of power and power factor in a single phase ac series inductive circuit and
study improvement of power factor using capacitor
4. Study of phenomenon of resonance in RLC series circuit and obtain resonant frequency.
5. Connection and measurement of power consumption of a fluorescent lamp (tube light).
6. Measurement of power in 3- phase circuit by two wattmeter method and determination of its
power factor for star as well as delta connected load.
7. Determination of parameters of ac single phase series RLC circuit
8. To observe the B-H loop of a ferromagnetic material in CRO.
9. Determination of (i) Voltage ratio (ii) polarity and (iii) efficiency by load test of a single phase
transformer
10. Determination of efficiency of a dc shunt motor by load test
11. To study running and speed reversal of a three phase induction motor and record speed in
both directions.
12. Demonstration of cut-out sections of machines: dc machine, three phase induction machine,
single-phase induction machine and synchronous machine.

You might also like