Last Resource System (Manual Brake Release)
Uploaded by
Juan Carlos MedinaLast Resource System (Manual Brake Release)
Uploaded by
Juan Carlos MedinaCMC4+ Last Resource System
This system will work only in Inspection or recall mode:
In Recall mode:
1. -S154 in EMERG. Position (recall mode)
2. Switch off main power supply (Q00 in down position).
3. Activate at the same time –S154.1 switch (in up or down direction) and –S72 Test
brake switch (in position I or II).
4. Leds indication:
• LED ESH will indicate Up direction.
• LED PROG will indicate Down direction
1 2
3
For more information, please check the manual: 1.4.2. Operation Manual_CMC4_Plus available
on our extranet websyte: https://extranet.thyssenkrupp-elevator-manufacturing-
spain.com/user/login?destination=node
CMC4+ Last resource system
March 2014
Technical Service – CSC NI ThyssenKrupp
1
[email protected]
Elevator Manufacturing Spain
CMC4+ Last Resource System
This system will work only in Inspection or recall mode:
In Inspection mode and lack of power supply:
1. Change to inspection mode on cabin top box.
2. Press at the same time: UP+COMMON+DOWN push buttons.
* Leds indication: There is no led indication since the technician is supposed to have
perception of movement and speed.
Pressed at the same time
1 2
Lack of power
supply
For more information, please check the manual: 1.4.2. Operation Manual_CMC4_Plus available
on our extranet websyte: https://extranet.thyssenkrupp-elevator-manufacturing-
spain.com/user/login?destination=node
CMC4+ Last resource system
March 2014
Technical Service – CSC NI ThyssenKrupp
2
[email protected]
Elevator Manufacturing Spain
