Scribd
Upload
42 views3 pages

EE2202 - EndSem QP-May2022

This document provides instructions and questions for the 4th semester end semester examination in Network Theory for B.Tech (EE) students at Indian Institute of Engineering Science and Technology, Shibpur. It contains 7 questions divided into two halves with 4-6 subparts each. Students must answer 4 questions by choosing 2 from each half. They have 1 hour and 30 minutes to complete the exam and must upload their answer scripts by 5:50pm.

Uploaded by

Harsh Agarwal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
42 views3 pages

EE2202 - EndSem QP-May2022

This document provides instructions and questions for the 4th semester end semester examination in Network Theory for B.Tech (EE) students at Indian Institute of Engineering Science and Technology, Shibpur. It contains 7 questions divided into two halves with 4-6 subparts each. Students must answer 4 questions by choosing 2 from each half. They have 1 hour and 30 minutes to complete the exam and must upload their answer scripts by 5:50pm.

Uploaded by

Harsh Agarwal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Indian Institute of Engineering Science and Technology, Shibpur

B.Tech. (EE) 4th Semester End Semester Examination, May 2022


Network Theory (EE-2202)

Full marks: 50 Time: 1 hour 30 minutes


(i) Answer questions of each half in one place
(ii) The questions are of equal value
(iii) Answer Four questions taking any Two from each half
(iv) One mark reserved for neatness in each half
(v) Upload Answer scripts by 5:50pm

FIRST HALF
(Answer any two questions)
1. a) What are the super-node and super-mesh concepts? Where are these used?
b) Find the Thevenin equivalent circuit at the terminals A-B in the circuit of Fig. 1.

Fig. 1.

c) Find the value of load impedance Z for which maximum power will flow through
the load. [4+6+2]

2. a) State and explain Millman’s Theorem for multiple current sources.


b) Find the Z-parameters of the network shown in Fig. 2.

Fig. 2.
c) Find suitable parameters of the h-parameters of the network shown in Fig. 3.

Fig. 3. [4+4+4]
(2)

3. a) A two-port network has the following impedances: Z1O = (250 + j100) ohm, Z2O =
200 ohm, Z1S = (400 + j300) ohm. Determine the Z-parameters of the equivalent
T-network.
b) The circuit shown in Fig. 3, is a combination of two interconnected networks.
Identify the interconnected networks and hence find the T-parameters of the
resultant network.

Fig. 4.

c) Find the voltage transfer function of the circuit shown in Fig. 5.

Fig. 5. [3+5+4]

4. a) Find the voltage across the 5 ohm resistor in the magnetically coupled circuit
shown in Fig. 6. Show all the induced emfs with polarity.

Fig. 6 [6]
b) Write critical notes on any two: [3×2]
(i) Telegen’s Theorem,
(ii) Energy stored in a mutually coupled inductor,
(iii) Compensation Theorem.
(3)

SECOND HALF
(Answer any two questions)

5 a) Write short notes on the followings:

(i) Planar and Non-Planar Graph with illustrations


(ii) Co-trees
(iii) Links

b) What is a reduced incidence matrix? Draw a directed graph for the given
reduced incidence matrix. A1 =
[ -1 0 0 0 1 0 1 0
0 -1 0 0 0 0 -1 1
0 0 -1 -1 0 -1 0 -1
0 0 0 0 -1 1 0 0 ] [6+6]

6. a) Write a brief note on types of filters and their general characteristics.

b) Design a low pass π-section filter with a cut-off frequency of 2kHz to operate
with a load resistance of 400 Ω. Also find the equivalent T-section network of
the π-section filter.
[6+6]

7. a) Explain the Hurwitz polynomials and positive real functions.

b) Discuss the difference between first Foster and second Foster form with
appropriate illustration for LC network. [6+6]

— xXx —

You might also like