Volumen flow transmitter

Volume flow transmitter

Type 679

The volume flow transmitter

tra type 679 have Bi-direction pressure
ranges. Variable measurement
m of pressure, flow or velocity of
flow is available.

Special sensors dev

developed for each pressure range guarantee a
physically precise aand long term stable measurement.
The diversity of versions
v ensure the use in many various
applications in HVA
HVAC or for fine measurement in the industry or
medical sector.

Measuring range + With LCD-Display

-1 ... 1 mbar / + Adjustable measurement range

0 ... 0.3 – 50 mbar + Switchable output signals

+ Resettable Zero Point (Reset button)
+ Full scale adjustable
+ Application at over and low pressure range possible
+ Fast, easy mounting. Housing incorporates integral bracket
for wall or ceiling mounting
+ Adjustable k-Factor for flow and velocity

Pressure and flow Huba Control Type 679 | Technical data subject to change | Edition 09/2020 1/5
 Technical overview
Measuring range
Flow and velocity for following pressure ranges -1 ... 1 mbar / 0 ... 0.3 – 50 mbar

Operating conditions
Medium Air and neutral gases
Medium / ambient 0 ... +70 ºC
Temperature Storage -10 ... +70 ºC
No condensation
< 3 mbar P1 = 50 mbar P2 = 4 mbar
Application at over pressure range
> 3 mbar P1 = 100 mbar P2 = 4 mbar
Tolerable overload on one side < 3 mbar P1 = -4 mbar P2 = -50 mbar
Application at under pressure range
> 3 mbar P1 = -4 mbar P2 = -100 mbar
ambient temperature 2 x overload
Rupture pressure
70 ºC 1.5 x overload

Materials in contact with medium

Sensor Ceramic Al2O3 (96%)
Diaphragm Silicone
Housing Polycarbonat PC

Electrical overview
Output 1) Power supply 1) Load Current consumption 2)
2 wire 4 ... 20 mA 8.0 ... 33 VDC < supply 0.02
voltage - 8 V
A [Ohm] < 20 mA
0 ... 10 V 13.5 ... 33 VDC / 24 VAC ±15% > 10 kOhm < 10 mA
0 ... 20 mA 13.5 ... 33 VDC / 24 VAC ±15% < 500 Ohm < 30 mA
3 wire 4 ... 20 mA 13.5 ... 33 VDC / 24 VAC ±15% < 500 Ohm < 30 mA
0 ... 5 V 3) 6.5 ... 33 VDC / 24 VAC ±15% > 10 kOhm < 10 mA
Filter Response time switchable by off / 0.2s / 1s / 5s / 20s
Polarity reversal protection Short circuit proof and protected against polarity reversal. Each connection is protected against crossover up to max. supply voltage.

Dynamic response
Response time < 20 ms
Load cycle < 10 Hz

Protection standard
Without cover IP 00
IP 54
With cover
IP 65

Display
Double spaced per 8 digit alphanumeric
LCD Display
At additional backlight LCD-Display 30 mA current consumption

Ranges of adjustment
The zero piont is adjustable by reset button.
The Full scale is adjustable by DIP-Switch and additional by the turbopoti.
Display adjustable between flow and velocity.
Pressure Flow: Velocity:
Available units:
mbar, Pa, mmWS, kPa, hPa, inH2O m3/s, m3/h, cfm, L/s m/s, fpm

Parameters are adjustable by customer

Pressure ranges in grades; stepless adjustable with Turbo-Poti / output signals / Unit / Output signal and additional 0 ... 5 V / filter (off / 0.2s / 1s / 5s / 20s) / k-Factor adjustable 0.0001 ... 9999 /
backlight (off / 5min / on)

Electrical connection
Screw terminals for wire and stranded conductors up to 1.5 mm2
Cable gland with built-in strain relief PG11

Pressure connection
Connection pipe Ø 6.2 mm

Mounting instructions
Installation arrangement Recommendation: Vertical, with pressure connections downwards
Mounting Mounting bracket (integrated in case)

Tests / Admissions
UL
Electromagnetic compatibility CE-conformity acc. EN 61326-2-3

Weight
~ 100 g

Packaging
Single packaging in cardboard
Multiple packaging 20 / 40 / 120

Accuracy
Parameters Unit ±0.5 mbar 0 ... 1 mbar 0 ... 3 mbar 0 ... 5 mbar 0 ... 10 - 50 mbar
Tolerance zero point max. % FS ±1.0 ±1.0 ±0.7 ±0.7 ±0.7
Tolerance full scale max. % FS ±1.0 ±1.0 ±0.7 ±0.7 ±0.7
Resolution % FS 0.2 0.2 0.1 0.1 0.1
Total of linearity, hysteresis and repeatability max. % FS ±1.0 ±1.0 ±1.0 ±1.0 ±0.6
Long therm stability acc. DIN EN 60770 % FS ±1.0 ±1.0 ±1.0 ±1.0 ±1.0
TC-Zero point 4) typ. % FS/10K ±0.2 ±0.2 ±0.2 ±0.1 ±0.1
TC-Zero point 4) max. % FS/10K ±1.0 ±1.0 ±0.5 ±0.4 ±0.4
TC sensitivity 4) typ. % FS/10K ±0.3 ±0.3 ±0.2 ±0.1 ±0.1
TC sensitivity 4) max. % FS/10K ±0.6 ±0.6 ±0.5 ±0.5 ±0.2

- no additional root-extracted errors Test conditions: 25 ºC, 45% rF, Power supply 24 VDC
- For changing diaphragm position, compensable with zero point reset TC z.p. / TC z.p. 0 … 70 ºC

1)
Adjustable by DIP-Switch 2)
At nominal pressure 3)
Additional adjustable by software 4)
TC = Temperature coefficient

2/5 Pressure and flow Huba Control Type 679 | Technical data subject to change | Edition 09/2020
 1 2 3 4 5 6 7 8 9 10

Order code selection table 679. X X X X X X X X X X

Pre-adjustment max. range 9
Pressure range of 0 % to 100% FS (diagram a) 1
Signal range selectable Pressure range of -10 % to 90% FS (diagram b) 2
Pressure range of -100 % to 100% FS (diagram c) 3
mbar (hPa) Pa mmWS inH2O under pressure max.
0 ...0.3/0.5 30/50 3/5 0.1/0.2 -50 Pa 0
0 ... 0.3/0.5/1 30/50/100 3/5/10 0.1/0.2/0.3 -100 Pa 1
0 ... 0.5/1/3 50/100/300 5/10/30 0.3/0.5/1 -50 Pa 2
Pressure range selectable 0 ... 1/3/5 100/300/500 10/30/50 0.5/1/2 -50 Pa 3
0 ... 3/5/10 300/500/1000 30/50/100 1/2/3 -50 Pa 4
0 ... 5/10/16 500/1000/1600 50/100/160 2/3/5 -50 Pa 5
0 ... 10/16/25 1000/1600/2500 100/160/250 3/5/10 -50 Pa 6
0 ... 16/25/50 1600/2500/5000 160/250/500 5/10/20 -50 Pa 7
mbar 0 2 6
Pa 2 2 6
mmWS 3 2 6
hPa 4 2 6
kPa 5 2 6
inH2O 6 2 6
mbar 8 3
m3/s
Pa 9 3
Unit
mbar E 3
m3/h
Pa F 3
cfm inH2O K 3
mbar M 3
L/s
Pa N 3
mbar S 3
m/s
Pa T 3
fpm inH2O Y 3
Linear with filter (transposable) 2 6
Output signal
Square root extracted with filter (transposable) 3
0 ... 10 V 13.5 ... 33 VDC / 24 VAC ± 15 % (3-Leiter) 1
0 ... 20 mA 13.5 ... 33 VDC / 24 VAC ± 15 % (3-Leiter) 3
Output / power supply 13.5 ... 33 VDC / 24 VAC ± 15 % (3-Leiter) 4
4 ... 20 mA
8.0 ... 33 VDC (2-Leiter) 5
at delivery no pre-adjustment 2 6
with display in pressure unit chosen above 1
Option
with display in %fs 2
without pressure orifices 1
Pressure connection / pressure orifices on P1 2
Connection pipe Ø 6.2 mm
pressure orifices pressure orifices on P2 3
pressure orifices on P1 and P2 4
without 0
IP 54 with connection kit (metal), 90º angled including tube 2 m long (Fig. 1) 1
Accessories / with connection kit (plastic), straight including tube 2 m long (Fig. 2) 2
connection Kit without 3
IP 65 with connection kit (metal), 90º angled including tube 2 m long (Fig. 1) 4
with connection kit (plastic), straight including tube 2 m long (Fig. 2) 5
Pressure range variation
(optinal) Indicate W and state range on order (e.g.: W0 ... + 8mbar/OUT1...6V) 1 W

Range of characteristic line

a) b) c)
Out
Out Out
100%
100% 100%

Zero @ 50%

Zero @ 10%
0%
0% Pressure 100% -10% 1) Pressure 90% -100%1) 0% 100%
Pressure

Accessories 2) Order number

Connection kit for vent duct (metal), 90º angled including tube 2 m long (Fig. 1) 104312
Connection kit for vent duct (plastic), straight including tube 2 m long (Fig. 2) 100064
DIN-rail mounting adapter (Fig. 3) 112854
Calibration certificate 104551

1)
under pressure max. acc. order code selection table = -50 Pa/ 100 Pa 2)
Accessories supplied loose

Pressure and flow Huba Control Type 679 | Technical data subject to change | Edition 09/2020 3/5
 Dimensions in mm / Electrical connections

2 wire 3 wire Universal

2 and 3 wire

Fig. 1 Fig. 2 Fig. 3

92 4

6 11.6
51

35.2
28

97

EN 60 715-TH 35-7.5

4/5 Pressure and flow Huba Control Type 679 | Technical data subject to change | Edition 09/2020
Huba Control AG
Headquarters Schweiz
Industriestrasse 17
CH-5436 Würenlos
Telefon +41 56 436 82 00
Fax +41 56 436 82 82
[email protected]

Huba Control AG Huba Control AG

Niederlassung Deutschland Vestiging Nederland
Schlattgrabenstrasse 24 Hamseweg 20A
D-72141 Walddorfhäslach NL-3828 AD-Hoogland
Telefon +49 7127 2393 00 Telefoon +31 33 433 03 66
Fax +49 7127 2393 20 Telefax +31 33 433 03 77
[email protected] [email protected]

Huba Control SA Huba Control AG

Succursale France Branch Office United Kingdom
Rue Lavoisier Unit 13 Berkshire House, County Park
Technopôle Forbach-Sud Business Centre, Shivenham Road
F-57602 Forbach Cedex Swindon - Wiltshire SN1 2NR
Téléphone +33 3 87 84 73 00 Phone +44 1993 77 66 67
Télécopieur +33 3 87 84 73 01 Fax +44 1993 77 66 71
[email protected] [email protected]

www.hubacontrol.com