BSC CARDS-APZ21233 C
CARD
CP-Magazine
RPBI-S
IPNAX
POWC
IPU
SPU
DSU
MAU
AP-Magazine
CPCI
LBB/RAID
LBB/AM
PSU/HDD
GS Magazine/GEM
SCB-RP
XDB
DLEB
ET1551/ETM2
IRB
CGB
CDB
CSPB
MUX/ETM2-Magazine
PDB
ETSFB(MUX)
CCFLI(DE- MUX)
RP-Magazine/GDM
RP4H
DLHB
RPP
RPG3
PCU Magazine-GDDM
EPS
BSC CARDS-APZ21255 C
CARD
CP-AP Magazine
CP SCB-RP
CP CPUB-8
CP MAUB
AP GEA
AP-DISK GED-SASF
AP APUB
AP GED-DVD
GS Magazine/GEM
SCB-RP
XDB-2
CSPB 2.0
ET155-1-0-2
IRB
CGB-2-CLM890
CDB
STEB
GARP2-TRHB
GARP2-GPHB
BSC CARDS-APZ21233 C
EXPANSION
Regional processor bus inteface-serial
Inter-Platform Network Adapter and Switch
Power Control Unit
Instruction Processor Unit
Signalling processor unit
Data storage unit
Maintenance unit
Compact Peripheral Component Interconnect
Large Building Block/Redundant Array of Inexpensive Disks
Large Building Block/Alarm Module
Program Store Unit/Hard Disk Drive
Support and Connection Board with RP
Distributed Switch Board
Digital Link multiplexer for Existing equipment Board
Exchange Terminal which terminates the 155.520 Mbit/s STM-1
interface to the SDH network
Incoming Reference Board
Clock Generator Board
Clock Distribution Board
Common Speech Processing Board
Regional Processor 4, Half height
Digital Link Half height Board
Regional Processor with Peripheral Component Interface
Regional Processor with Group switch interface for the serial RP
bus
Ethernet Packet Switch
BSC CARDS-APZ21255 C
EXPANSION
Support and Connection Board with RP
Central Processor Unit Board
Maintenance unit Board
Generic Ericsson Alarm board
Generic Ericsson Device board-Serial Attached Small Computer
System Interface Front
Adjunct Processor Unit Board
Generic Ericsson Device board-Digital Versatile Disc
Support and Connection Board with RP
Distributed Switch Board
Common Speech Processing Board
Exchange Terminal which terminates the 155.520 Mbit/s STM-1
interface to the SDH network
Incoming Reference Board
Clock Generator Board
Clock Distribution Board
Signalling Terminal Enhanced Board
Generic Application Resource Processor - Transceiver Handler
Board
Generic Application Resource Processor - GPRS Packet Handler
board
Functionality TYPE
The purpose of RPBIS board is to provide a connection
for up to 320 RPs for
the CP via the Regional Processor Bus, RPB.
IPN will be used to speed up
communication between the central processor
(CP) and adjunct processors (AP). The
interface is based on fast Ethernet.
Power for CPU
execution part ipu
administration part spu
For PS,DS,RS
This will monitor both CP, Wen it found faulty from
any CP it change the SB CP to WO CP
Used for RP bus connectivity
Group switch card.16k capacity.
It has 5ports,ie.acts like amultiplexer,ie..2K device it
carries.
Acts like a demultiplexer
Internal reference board.Reference signal is given.
Clock signal generation
Connected to XDB board
Echo cancellor ECP-
To connect RP to CP throuh This RP4H
Multiplexer card.ie..32*16=512 devices can handle
HSL/GPRS C7snth
LAPD/LSL/ C7snt-
EPSB is a non-blocking Ethernet switch which can be
used to create a local data network between RPPs.The
EPSB can be used to create a high-speed
communication path between the RPPs within the
same exchange.
Functionality
Provides switching capabilities between magazines as
well as within the magazine. External power is
connected to this board.
CPU
The MAUB implements the maintenance unit function
in APZ 212 55. It
interfaces with both CP sides, CDU, SCB-RP and
maintains the two CP sides.
processor board for APG43
RPSCB1E
It supports all codecs used in GSM system, i.e. EFR, FR,
HR and Adaptive MultiRate codec (AMR) HR & FR. It
also supports TFO for EFR, AMR-FR and AMR-HR.The
TRA R7 is built in a DSP ASIC technology developed
especially for speech processing. This results in the
ability to handle 384 speech channels per board, small
size and low power consumption. Compare to TRA R6,
the channel density is not reduced when running TFO
for narrowband codecs. It is connected to the Group
Switch via a DL34 interface and is controlled by the
APZ via an on-board regional processor (RPI).
The IRB receives three external synchronization
references that are terminated, converted and
distributed to the CGBs.
CGB generates Clock and Synchronization signal to the
switch.Two CGBs are housed in the same GEM, in case
of one GEM configuration (16 kMUPs). If the switch
size is bigger than 16 kMUPs the CGBs are housed in
different GEMs in order to improve the reliability of
the system.
The CDB distributes clock and synchronization to the
switch. It is necessary if the switch is bigger than 16
kMUPs.
The STEB implements signalling terminal (ST)
functionalities of No. 7 signalling using Nb and HSL
protocol in AXE 810 system. STEB supports up to: 4
HSL links or 128 Nb signalling links.
RPALI1E
The Generic Application Resource Processor ver. 2
(GARP-2) is equipped with a MPC 8548E processor
and 1GB of DDR SDRAM. Connected to the processor
via an PCI Express interface is an FPGA. The FPGA is
connected to the DL34 interface in the backplane.
GARP-2 has two Gigabit Ethernet interfaces in the
backplane and two on the front
MSC/MSS CARDS
CARD
CP-Magazine
RPIO-2
CPHU
PCIH
UPBB3
RPHMI
RPHU POU-R
GS Magazine/GEM
LRB
GARP-1
GESB
RP-Magazine/GDM
M-AST
TTA
PDSPL2E
PCD-G
In MSC/MSS IPU,SPU,DSU&MAU not present
MSC/MSS CARDS
EXPANSION Functionality
Regional processor input/output
The signals between the CPSB and PCIH are
send over Ethernet. The PCIH board controls
Peripheral Component Interconnect Handler Board the RPHMI and UPBB boards
The communication between PCIH and
UPBB/ RPHMI is done over a cPCI buss. This
is a buss on the magazine backplane.
Update Bus Board Maintains CP sw
Regional Processor Handler Magazine
Interface Board To indicate working state of CP
Power Unit Board in RPHU
LRB(Local reference board) is used for
Local Reference Board Internal clock
The General Application Regional Processors
(GARP) are used as
Generic Application Resource Processor type 1 Sigtran Interface, GCP Handlers,
Authentication Centre or for the
Network Time Protocol (NTP)
Gigabit Ethernet Switch Board internal communication b/w cp&ap
Next Generation Modular Announcement Service Terminal Announcement service device supervision asds-
Terminating Transport Area Used to connect test phone(BL)
Pooled Digital Signalling processor PLatform version 2 Programmable digital signal processing
with Load module loadable.used as CCD ie..call conferencing
etc.
PDSPL2 based Generic Pulse Code Device
MGW CARDS
CARD
SCB3
GPB5 3
MSB3
ETC41
SXB3
TUB
ETMC1
ETMFG
CCF E1/T1 Board
OPTOBOARD
Power Connection Unit
MGW CARDS
EXPANSION Functionality
The SCB handles all the data switching
between the different boards of the node. It
can also be used to connect the different
extension subracks to the main subrack. The
Switch Core Board connections are done by using Inter Subrack
Links (ISLs).
SCBs always exist in pairs, installed in each
subrack in slots 1 and 28.
it act as CP in MGW, present in slot 2 and3 in
General Purpose Processor Board main rack
The MSB board is used for the user data
processing. It can be loaded with different
Media Stream Board SW applications to support different data
processing configurations.
Exchange Terminal Board type ET-C41 4 STM(Both TDM and ATM signaling used)
The SXB is used when the Inter Subrack Link
(ISL) capacity of the SCB boards are not
Switch Extension Board sufficient to support all the traffic needed.
The connections are done using Inter
Subrack Links (ISLs).
The Timing Unit Board version 2 (TU2)
Timing Unit Board board is used for the generation of stable
clock signal and synchronization of the node.
8E1s used(used for ATM signaling(i.e only
Exchange Terminal Board type ET-MC1 HSL)
Exchange Terminal Board type ET-Multi Function Gigabit The ET-MFG is an exchange terminal that
Ethernet enables direct IP connections to a M-MGw
node. (MPBN connectivity)
The CCF E1/T1 board has four electrical
Conversion and Connection Field E1/T1 Board ports for external interface connections.
The CCF Opto board has six optical ports for
external interface connections.
Power Connection Unit is comptaible with
high-ohmic power distribution systems.
BSC-APZ21233 C
CP-Magazine AP-Magazine GS Magazine/GEM MUX/ETM2-Magazine
RPBI-S CPCI SCB-RP PDB
IPNAX LBB/RAID XDB ETSFB(MUX)
POWC LBB/AM DLEB CCFLI(DE- MUX)
SPU PSU/HDD ET1551
IPU IRB
DSU CGB
MAU CDB
CSPB
MSC -APZ21250C
CP-Magazine AP-Magazine GS Magazine/GEM MUX/ETM2-Magazine
RPBI-S CPCI SCB-RP PDB
IPNAX LBB/RAID XDB ETSFB
POU-R LBB/AM DLEB CCFLI
RPIO-2 PSU/HDD ET1551
IRB
CGB
CDB
CSPB
CL890CGB
LRB
Note:
GEM-Generic Ericsson Magazine-26 slots with 22dev
GDM-Generic device Magazine-20 slots with 16dev
In addition to MSC MSS have GARP-1,GESB card in GEM magazine
In addition to MSC MSS have PCIH,UPBB3,RPHMI card in CP magazine
In MSC/MSS IPU,SPU,DSU&MAU not present
MGW-GMPV3.0
SCB3 CCF E1/T1 Board
GPB5 3 OPTOBOARD
MSB3 Power Connection Unit
ETC41
SXB3
SCB3
TUB
ETMC1
ETMFG
BSC-APZ21255
CP-AP Magazine GS Magazine/GEM
SCB-RP SCB-RP
GEA XDB-2
CPUB-8 CSPB 2.0
MAUB ET155-1-0-2
GED-SASF IRB
APUB CGB-2-CLM890
GED-DVD CDB
STEB
GARP2-TRHB
GARP2-GPHB
RP-Magazine/GDM PCU Magazine-GDDM
RP4-H RP4-H
DLHB DLHB
RPP RPP
RPG3 EPS
RP-Magazine/GDM PCU Magazine-GDDM
RP4-H RP4-H
DLHB DLHB
RPP RPP
RPG3 EPS
MAST
TTA
PDSPL2E
PCD-G
ALEX Active Library Explorer (ALEX)
MML MAN MACHINE LANGUAGE
HDD Hard Disk Drive
DAT DIGITAL AUDIO TAPE
