RRZZHHTTS4-65B-R7 Product Specification (Comprehensive)
RRZZHHTTS4-65B-R7 Product Specification (Comprehensive)
General Specifications
Antenna Type Sector
Band Multiband
Grounding Type RF connector inner conductor and body grounded to reflector and
mounting bracket
Performance Note Outdoor usage | Wind loading figures are validated by wind tunnel
measurements described in white paper WP-112534-EN
Page 1 of 7
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: May 11, 2020
RRZZHHTTS4-65B-R7
Dimensions
Width 498 mm | 19.606 in
Array Layout
Port Configuration
Page 2 of 7
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: May 11, 2020
RRZZHHTTS4-65B-R7
Electrical Specifications
Impedance 50 ohm
Operating Frequency Band 1427 – 2690 MHz | 3300 – 3800 MHz | 694 – 960 MHz
Polarization ±45°
Page 3 of 7
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: May 11, 2020
RRZZHHTTS4-65B-R7
Internal RET High band (5) | Low band (2)
Electrical Specifications
R1-R2 R1-R2 B1-B2 Y1&Y4 Y2-Y3 Y2-Y3 Y2-Y3 P1
Frequency Band, MHz 694–790 790–960 1695–2180 2490–2690 1427–1518 1695–2180 2300–2690 3300–3800
Gain, dBi 14.7 15.3 17.9 18.7 15 17 17.7 16
Beamwidth, Horizontal, 71 63 66 59 66 62 58 89
degrees
Beamwidth, Vertical, degrees 10.5 8.8 5.2 4.1 9.3 7.3 5.6 6.5
Beam Tilt, degrees 2–12 2–12 2–12 2–12 2–12 2–12 2–12 2–12
USLS (First Lobe), dB 15 16 18 25 18 18 20 15
Front-to-Back Ratio at 180°, 32 30 33 30 33 35 31 31
dB
Coupling level, Amp, 26
Antenna port to Cal port, dB
Coupling level, max Amp Δ, ±2
Antenna port to Cal port, dB
Coupler, max Amp Δ, 0.9
Antenna port to Cal port, dB
Coupler, max Phase Δ, 7
Antenna port to Cal port,
degrees
Isolation, Cross Polarization, 28 28 28 28 26 27 26 25
dB
Isolation, Inter-band, dB 28 28 28 28 27 27 27 20
VSWR | Return loss, dB 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0
PIM, 3rd Order, 2 x 20 W, dBc -150 -150 -150 -150 -150 -150 -150 -145
Input Power per Port at 50° 300 300 250 150 250 250 200 50
C, maximum, watts
Beamwidth, Horizontal ±6.5 ±4.7 ±6.7 ±4.7 ±4.8 ±6.4 ±5.6 ±20
Tolerance, degrees
Beamwidth, Vertical ±0.7 ±0.8 ±0.5 ±0.2 ±0.7 ±0.8 ±0.5 ±0.6
Page 4 of 7
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: May 11, 2020
RRZZHHTTS4-65B-R7
Tolerance, degrees
USLS, beampeak to 20° 15 16 16 16 15 17 16 15
above beampeak, dB
Front-to-Back Total Power at 21 21 26 23 22 28 26 23
180° ± 30°, dB
CPR at Boresight, dB 21 19 20 19 19 19 17 17
CPR at Sector, dB 15 10 7 6 8 8 3 9
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: May 11, 2020
RRZZHHTTS4-65B-R7
Mechanical Specifications
Wind Loading at Velocity, frontal 180.5 lbf @ 150 km/h | 803.0 N @ 150 km/h
Wind Loading at Velocity, lateral 275.0 N @ 150 km/h | 61.8 lbf @ 150 km/h
Wind Loading at Velocity, maximum 1,040.0 N @ 150 km/h | 233.8 lbf @ 150 km/h
Regulatory Compliance/Certifications
Agency Classification
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
Included Products
BSAMNT- — Wide Profile Antenna Downtilt Mounting Kit for 2.4 - 4.5 in (60 - 115 mm) OD round members. Kit contains one scissor top
4 bracket set and one bottom bracket set.
* Footnotes
Performance Note Severe environmental conditions may degrade optimum performance
Page 6 of 7
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: May 11, 2020
BSAMNT-4
Wide Profile Antenna Downtilt Mounting Kit for 2.4 - 4.5 in (60 - 115
mm) OD round members. Kit contains one scissor top bracket set
and one bottom bracket set.
General Specifications
Application Outdoor
Color Silver
Dimensions
Compatible Diameter, maximum 114.3 mm | 4.5 in
Material Specifications
Material Type Galvanized steel
Packaging quantity 1
Regulatory Compliance/Certifications
Agency Classification
CHINA-ROHS Below maximum concentration value
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
REACH-SVHC Compliant as per SVHC revision on www.commscope.com/ProductCompliance
ROHS Compliant
Page 7 of 7
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: April 27, 2020