Scribd
Upload
143 views14 pages

SRS Renesas

The document discusses clearing crash data from airbag control modules used in Toyota, Honda, Subaru, and Lexus vehicles. These modules often use Renesas microcontrollers that require putting the MCU into boot mode by applying power to the reset pin in order to erase crash data stored in EEPROM memory. The steps provided erase the flash memory and EEPROM to clear any recorded crash events from the module.

Uploaded by

g.a.r.jayanga
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
143 views14 pages

SRS Renesas

The document discusses clearing crash data from airbag control modules used in Toyota, Honda, Subaru, and Lexus vehicles. These modules often use Renesas microcontrollers that require putting the MCU into boot mode by applying power to the reset pin in order to erase crash data stored in EEPROM memory. The steps provided erase the flash memory and EEPROM to clear any recorded crash events from the module.

Uploaded by

g.a.r.jayanga
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 14

Conducted by

Eng K Asela Perera


 TOYOTA, HONDA, SUBARU , LEXUS used
Denso and Fujitsu Airbag Modules
 The MCU is Renesas in most Denso Modules
H8SX ( 1725 or 1797)
Open Iprog and direct to Airbag – Renesas – Toyota Denso CAN
 Now your Module is in Work Mode. In work
Mode
◦ Only Read and Erase Flash Can be done
Note That Crash is in the EEPROM and need to
clear it
To clear EEPRO we need to put the MCU in Boot
Mode
Giving Controlled Power to RST pin is the Boot Procedure of this Renesas
MCUs
Giving Controlled Power to RST pin is the Boot Procedure of this Renesas
MCUs
Giving Controlled Power to RST pin is the Boot Procedure of this Renesas
MCUs
Giving Controlled Power to RST pin is the Boot Procedure of this Renesas
MCUs
Giving Controlled Power to RST pin is the Boot Procedure of this Renesas
MCUs
Giving Controlled Power to RST pin is the Boot Procedure of this Renesas
MCUs
Giving Controlled Power to RST pin is the Boot Procedure of this Renesas
MCUs
1. Read ECU Info for confirm the Communication
Status
2. Read Flash on work Mode and save it
3. Erase Flash in Work Mode
4. Put the MCU to Boot Mode by Resistor soldering
5. Erase EEPROM
6. Write Saved Flash Back
7. Remove Boot Resistor and Solder any removed
components

Now the Crash is cleared

You might also like