0% found this document useful (0 votes)
85 views

Gas Viscosity

The document discusses methods for estimating the viscosity of natural gas in reservoirs. It explains that gas viscosity depends on pressure, temperature, and gas composition. It then describes the Carr-Kobayashi-Burrows correlation method, which uses pseudocritical properties, viscosity charts, and composition to calculate gas viscosity at different conditions. The document also outlines the Lee-Gonzalez-Eakin method, which estimates viscosity based on gas density, temperature, and molecular weight. An example application of each method is provided.
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
85 views

Gas Viscosity

The document discusses methods for estimating the viscosity of natural gas in reservoirs. It explains that gas viscosity depends on pressure, temperature, and gas composition. It then describes the Carr-Kobayashi-Burrows correlation method, which uses pseudocritical properties, viscosity charts, and composition to calculate gas viscosity at different conditions. The document also outlines the Lee-Gonzalez-Eakin method, which estimates viscosity based on gas density, temperature, and molecular weight. An example application of each method is provided.
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 14

Reservoir

Engineering П
Reservoir fluid properties

By
Assist lect. Farah N. Almohmmad
Viscosity of Natural Gas
• The viscosity of a fluid is a measure of its internal friction
resistance to flow.

• Gas, having significantly lower viscosity than oil and


water, tends to dominate multiphase flow in the reservoir.

• So, the knowledge of natural gas viscosity is essential for


the studies on the dynamic/flow behavior of a gas through
reservoirs.

• The gas viscosity is not commonly measured in the


laboratory because it can be estimated precisely from
empirical correlations
Gas Properties
Farah N. Almohammad
Viscosity of Natural Gas
• Like all intensive properties,the viscosity of a
natural gas can be completely described by
the following function:

• µ 𝑔 = 𝑓( 𝑃, 𝑇, γ𝑔 )

• This relationship states that gas viscosity is a


function of pressure, temperature, and
composition of the gas.
Gas Properties
Farah N. Almohammad
Carr-Kobayashi-Burrows
Correlation Method
1. Calculate the pseudo-critical pressure, pseudo-critical
temperature, and apparent molecular weight from the
specific gravity or the composition of the natural gas.
Corrections to these pseudocritical properties for the
presence of the nonhydrocarbon gases (CO2, N2, and
H2S) should be made if they are present in
concentrations greater than 5 mole percent.

2. Obtain the viscosity of the natural gas at one atmosphere


and thetemperature of interest from Figure 1. This
viscosity, as denoted by μ1, must be corrected for the
presence of nonhydrocarbon components.

µ1 = µ1 𝑢𝑛𝑐𝑜𝑟𝑟𝑒𝑐𝑡𝑒𝑑 + (Δµ)𝑁2 + (Δµ)𝐶𝑂2 + (Δµ)𝐻2𝑆


Gas Properties
Farah N. Almohammad
Carr-Kobayashi-Burrows
Correlation Method
3. Calculate the pseudo-reduced pressure and
temperature.

4. From the pseudo-reduced temperature and pressure,


obtain the viscosity ratio (μg/μ1) from Figure 2. The
term μg represents the viscosity of the gas at the
required conditions.

5. The gas viscosity, μg, at the pressure and temperature


of interest is calculated by multiplying the viscosity
at one atmosphere and system temperature, μ1, by
the viscosity ratio

Gas Properties
Farah N. Almohammad
Carr-Kobayashi-Burrows
Correlation Method

T (°F)

μ1

Ma gas
Gas Properties
Farah N. Almohammad
Carr-Kobayashi-Burrows
Correlation Method

(𝚫µ)𝐇𝟐𝐒
Mole fraction of
H2S in %

Gas Properties
Farah N. Almohammad
Carr-Kobayashi-Burrows
Correlation Method

Ppr

(𝝁𝒈/𝝁𝟏)

Tpr

Gas Properties
Farah N. Almohammad
Carr-Kobayashi-Burrows
Correlation Method
Example:

A gas well is producing at a rate of 15,000


ft3/day from a gas reservoir at an average
pressure of 2,000 psia and a temperature of
140°F. The specific gravity is 0.72. Calculate
the gas viscosity.

Gas Properties
Farah N. Almohammad
Carr-Kobayashi-Burrows
Correlation Method

Gas Properties
Farah N. Almohammad
The Lee-Gonzalez-Eakin Method
The authors expressed the gas viscosity in terms of the reservoir
temperature, gas density, and the molecular weight of the gas.

ρ𝑔 𝑌
• µ𝑔 = 10;4 𝐾 exp 𝑋
62.4

(9.4:0.02𝑀𝑎 )𝑇 1.5
• 𝐾=
209:19𝑀𝑎 :𝑇

986
• 𝑋 = 3.5 + + 0.01 𝑀𝑎
𝑇

• 𝑌 = 2.4 − 0.2 𝑋
Gas Properties
Farah N. Almohammad
The Lee-Gonzalez-Eakin Method

• ρg = gas density at reservoir pressure and


temperature, lb/ft3
• T = reservoir temperature, °R
• Ma = apparent molecular weight of the gas mixture

• The correlation is less accurate for gases with higher


specific gravities.

• The authors pointed out that the method cannot be


used for sour gases.
Gas Properties
Farah N. Almohammad
The Lee-Gonzalez-Eakin Method

• Example
• A gas well is producing at a rate of 15,000
ft3/day from a gas reservoir at an average
pressure of 2,000 psia and a temperature of
140°F. The specific gravity is 0.72. Calculate
the gas viscosity.

Gas Properties
Farah N. Almohammad
The Lee-Gonzalez-Eakin Method

Gas Properties
Farah N. Almohammad

You might also like