1 Makara J. Sci.

18/1 (2014), xxx-xxx

2 doi: 10.7454/mss.vxxix.xxxx

1 Title of Paper (14 pt, Title Case, Boldface)

2 (one blank single space line, 14 pt)

3 First Author1,2*, Second Author1, Third Author2 (12 pt)

4 (one blank single space line, 12 pt)

5 1. Department, Faculty, University, Address, City, Zip Code, Country (10 pt)

6 2. Research Group, Institution, Address, City, Zip Code, Country (10 pt)
*
7 e-mail: corresspondent author@institution address.com (10 pt)

8 (two blank single space line, 12 pt)

9 Abstract (12 pt, bold)

10 (one blank single space line, 12 pt)

11 Abstract should be written in both English and bahasa Indonesia. The abstract is written with Times

12 New Roman font size 10, and single spacing. The abstract should summarize the content of the

13 paper, including the aim of the research, research method, and the results, and the conclusions of the

14 paper. It should not contain any references or displayed equations. The abstract should be no more

15 than 200 words.

16 (one blank single space line, 12 pt)

17 Keywords: up to 5 keywords in English (10 point font, italics); write alphabetically in 5 words.

18 (three blank single space line, 12 pt)

19 1. Introduction (12 pt, bold)

20 (one blank single space line, 10 pt)

21 The manuscript is written with Times New Roman font size 10, single-spaced, left and right

22 alligned, on one-sided pages and on A4 paper (210 mm x 297 mm) with the upper margin of 3.5

23 cm, lower 2.5 cm, left and right each 2 cm. The manuscript including the graphic contents and

24 tables should be between 4 to 8 pages. If it far exceeds the prescribed length, it is recommended to

3 1 Month 201x | Vol. xxx | No. xxx

 4 2 Author’s name

25 break it into two separate manuscripts. The manuscript is written in English. The Standard English

26 grammar must be observed. The title of the article should be brief and informative and it should not

27 exceed 20 words. The keywords are written after the abstract.

28

29 The first letter of headings is capitalized and headings are numbered in Arabic numerals. The

30 organization of the manuscript includes Introduction, Methods or Experiment, Results and

31 Discussion, Conclusions and References. Acknowledgement (if any) is written after Conclusion

32 and before References and not numbered. The use of subheadings is discouraged. Between

33 paragraphs, the distance is one space.

34

35 Abbreviations/Terms/Notations/Symbols. The use of abbreviations is permitted, but the

36 abbreviation must be written in full and complete when it is mentioned for the first time and it

37 should be written between parentheses. Terms/foreign words or regional words should be written in

38 italics. Notations should be brief and clear and written according to the standardized writing style.

39 Symbols/signs should be clear and distinguishable, such as the use of number 1 and letter l (also

40 number 0 and letter O).

41

42 2. Tables (12 pt, bold)

43 (one blank single space line, 10 pt)

44 Tables are written with Times New Roman font size 10 and single spaced below the title of the

45 table. The title of the table is written with font size 9 (boldface) above the table as prescribed in the

46 format given below as example. The table is numbered in Arabic numerals. There is one single

47 space line between the table and the paragraph. The table is placed immediately after it is referred to

5 Makara J. Sci. Month 201x | Vol. xxx | No. xxx

 6 Title of Paper (10 pt, Time new roman, max. 50 character) 3

48 in the text. The frame of the table uses 1 font- size line. If the title in each table column is long and

49 complex, the columns are numbered and the notes are given below the table.

50 (one blank single space line, 10 point font)

51 Table 6. Elements in S. trifasciata Biosorbent (9 pt, boldface)

52 (one blank single space line, 6 point font)
Before Pb(II) treatment After Pb(II) treatment
Element Weight Abundance Weight Abundance
(%) (%) (%) (%)
C 48.79 56.47 38.90 50.33
O 49.05 42.62 49.39 47.97
Ca 1.23 0.43 2.65 1.03
Al 0.93 0.48 - -
Pb - - 9.06 0.68
53 (one blank single space line, 10 point font)

54 3. Graphic Contents (12 pt, bold)

55 (one blank single space line, 10 pt)

56 Graphic contents are placed symmetrically on the page and there is one blank single space line

57 between the graphic content and the paragraphs. A graphic content is placed immediately after it is

58 referred to in the body of the text and is numbered in Arabic numerals. Caption for the graphic

59 content is written below it and there is one blank single space line between it and the graphic

60 content. The caption is written in font size 9, boldface, and placed as in the example. Between the
Rejection (%)

61 graphic content with the body of the text there are two blank single space lines.
62

t (minute)

63 (Two blank single space line, 10 pt)

64 Figure 1. Value of Chitosan Membrane Rejection, A1, A2, B1, and B2 on the Artificial
65 Wastewater; Chitosan (■), A1 (), A2 (X), B1 (), B2 () (9 pt, boldface)

7 Makara J. Sci. Month 201x | Vol. xxx | No. xxx

 8 4 Author’s name

66 For any graphic contents which have been published by another author, the corresponding author

67 must obtain a written permission from that other author and his/her publisher. Include one graphic

68 content which is printed in good quality in a full-size page or scanned graphic content in good

69 resolution in the format as follows {name of file}.jpeg, or {name of file}.tiff. If the graphic content

70 is in the form of photograph, include one original photograph. The photograph is printed in black

71 and white unless the photograph will appear in color. The author will be charged an additional fee

72 for color printing of more than 1 page. The font face to be used in the graphic content or graph

73 should be the one generally available in each word processor and operational system such as

74 Symbol, Times New Roman and Arial with the font size not less than 9 point.

75

76 4. Reaction or Mathematical Equation (12 pt, bold)

77 (one blank single space line, 10 pt)

78 The reaction or mathematical equation should be positioned symmetrically on the column,

79 marked by sequential numbers written on the right corner within brackets. If the writing of equation

80 takes more than one line, numbers should be written on the last line. Letters used as mathematical

81 symbols in the text should be written in italics such as x. Equations in the text should be referred to

82 as abbreviations, for example Eq.(1) or Eq.(2).

83 (one single space, 10 pt)

84 (1)

85 (one single space, 10 pt)

86 Equation (1) is obtained using a Style format as the following: Variable: Times New Romans Italic

87 and LC Greek: Symbol Italic. Format size: Full 10 pt, Subscript/Superscript 8 pt, Subsubscript/Sub-

88 superscript 6 pt, Symbol 11 pt and Sub-symbol 9 pt. Elaboration of mathematical equation or

9 Makara J. Sci. Month 201x | Vol. xxx | No. xxx

 10 Title of Paper (10 pt, Time new roman, max. 50 character) 5

89 formula need not be written in detail; write only the most important part, the method used, and the

90 final result.

91

92 Citations in the text should be written using Arabic numbers and put in order in accordance to what

93 they refer to in the text. Numbers should be written in square brackets such as ”... Zhang et al.

94 [1] ....” Citations should be written one space away from the words after commas or periods and

95 before colons (:), semicolons (;), and question marks (?). If located at the end of a sentence,

96 citations should be put before periods such as ”.... by several researchers [2-3].” All citations should

97 then be written in the right order in the list of references at the end of the text, with the writing

98 procedure as illustrated in the example.

99

100 Appendices

101 (empty one single space, 20 pt)

102 Appendices are used only if really necessary, located before References and after Acknowledgement

103 (if any). If there is more than one Appendix, they have to be written in alphabetical order.

104

105 References

106 (empty one single space, 10 pt)

107 References should be written following the order they appear in the text, using Arabic numbers in

108 square brackets, as seen in the example. References should consist of initials and writers’ names,

109 names of journals or titles of books, volumes, editors (if any), publishers and their cities, years of

110 publication, and pages. All writers’ names have to be mentioned. Use the abbreviation ”Anon” if

111 writers are anonymous. Names of journals should be written using the commonly-used

112 abbreviations.

11 Makara J. Sci. Month 201x | Vol. xxx | No. xxx

 12 6 Author’s name

113 Journal article

114 [1] Z. Zhang, F. Wu, H.J.W. Zandvliet, B. Poelsema, H. Metiu, M.G. Lagally, Phys. Rev. Lett. 74

115 (1995) 3644.

116 [2] A. Erdemir, C. Bindal, J. Pagan, P. Wilbur, Surf. Coat. Technol. 76/77 (1995) 559.

117 [3] S. Auzary, K.F. Badawi, L. Bimbault, J. Rabier, R.J. Gaboriaud, P. Goudeau, J. Phys. III 7

118 (1997) 35 (in French).

119 [4] G. Smith, Thin Solid Films (to be published).

120 Electronic publication, information from the internet

121 [5] F. Yu, X.-S. Wu, Phys. Rev. Lett. 68 (1992) 2996. hep-th/9112009.

122 [6] L. Weiss, Instruction to Authors, Elsevier Publishing,http://www.elsevier.com/authors.html, 1999.

123 Conference Proceeding

124 [7] C.H. Perry, F. Lu, F. Namavar, N.M. Kalkhoran, R.A. Soref, Material Res. Soc. Symp. Proc.

125 256 (1991) 153.

126 [8] J.J. Favier, D. Camel, Proceedings of the Eight International Conference on Crystal Growth,

127 York, U.K., 1986, p.50.

128 Monograph, edited book, book

129 [9] M.J. Carr, C.E. Lymar, J.M. Cowley, In: J.M. Cowley (Ed.), Electron Diffraction Technique,

130 vol. 1, International Union of Crystallography/ Oxford University Press, New York, 1992, p.122.

131 [10] M.J. Adams, B.J. Briscoe, S.K. Sinha, in: D. Dowson, C.M. Taylor, T.H.C. Childs, M. Godet,

132 G. Dalmas (Eds.), Dissipative Processes in Tribology, Tribology Series, vol. 27, Elsevier,

133 Amsterdam, 1994, p.223.

134 [11] D. Palik (Ed.), Handbook of Optical Constants of Solids II, 3rd ed., Academic Press, New

135 York, 1991, p.151.

136 [12] S.M. Sze, The Physics of Semiconductor Devices, Wiley, New York, 1981, p.245.

13 Makara J. Sci. Month 201x | Vol. xxx | No. xxx

 14 Title of Paper (10 pt, Time new roman, max. 50 character) 7

137 Theses, Dissertations

138 [13] R. Ramos, Ph.D Thesis, College van Dekanen, University of Twente, The Netherland, 1992.

139 [14] S. Badu, Undergraduate Thesis, Department of Chemistry, Faculty of Mathematics and Natural

140 Sciences, Universitas Indonesia, Indonesia, 1990.

141 Patent

142 [15] H. Yamagishi, A. Hiroe, H. Nishio, K. Miki, K. Tsuge, Y. Tawada, U.S. Patent No. 5264710,

143 23 Nov. 1993.

144 Papers and Industrial Reports

145 [16] J. Cleveland, Spring Constant Update, Digital Instruments, Santa Barbara, 1996. [if a website

146 address available, it could be included in italic].

147 [17] R.D. Nicholson, International Structures In Nickelbased Transitions Joints After Long Term

148 Service, Report RD/M/N1131, Central Electricity Generating Board, Marchwood, 1980.

149 Special data (if written by a team or anonymously)

150 [18] Joint Committee on Powder Diffraction Standards, Powder Diffraction File, ASTM,

151 Philadelphia, 1967, Card 4301027.

152 [19] Anon., 19-th Annual Book of ASTM Standards Part 17, ASTM, Philadelphia, 1969, p.636.

153 Unpublished reports(refered only if necessary)

154 [20] R. Stumpf, X. Gonze, M. Scheffler, Fritz-Haber Institute Research Report, 1990, unpublished.

155 [21] A. Roberts, S.M. Lanoix, unpublished.

156 [22] D.H. Smith, Physics Departement, Chicago University, Chicago, U.S.A., private communication,

157 1986.

15 Makara J. Sci. Month 201x | Vol. xxx | No. xxx