SIGMA XT ANCILLARY PCB

Extinguishant Ancillary PCB

Features

Two wire serial connection
 to 7 per system
Up

230V AC or 24V DC powered versions

Volt free relay outputs for fire and extinguishing system
status

Relay operated LED indicators

Description
The Sigma XT Ancillary Board is compatible with all Sigma XT control panels A mixture of status units and ancillary boards, up to a maximum of 7 of each
which have operating software version SIGXT_11A.HEX or above. type, can be connected to the serial data bus.

The board provides volt free normally open contacts allowing control of sub-
systems and plant remotely from the main panel over a two wire data bus.

Mains powered, boxed Ancillary boards require only a two core data cable
from the main control panel. 24V DC versions require an additional two
cores for power either from the main panel or from another 24V DC source.

Up to 7 Ancillary boards can be connected to a control panel and each is

allocated an address from 1 to 7 using a binary coded DIL switch. The total
length of the data cable from the main panel to the last repeater must not
exceed 1200 metres.

Specification

Construction (boxed) 1.2mm mild sheet steel

IP rating (boxed) IP30

Colour - lid & box BS 00 A 05 grey - fine texture

Weight 1kg

Supply voltage (K03750M2) 230V AC (+10%/-15%)

Supply voltage (K03000M2) 20-30V DC

Mains supply fuse 1.6A 250V

Power supply DC rating 24V 0.75 Amp

Maximum battery size 2Ah 24V (2 per panel)

Contact ratings 30V DC 1 Amp

Cable capacity 2.5mm² per terminal

Operating temperature -5°C to +50°C

Operating humidity <95% (non condensing)

For further information visit www.kentec.co.uk

Equipment
Product Code Description Size
K588 Stand alone ancillary PCB 155 x 136

K03000M2 Boxed ancillary PCB 385 x 310 x 90

K03750M2 Boxed ancillary PCB with 0.75A PSU 385 x 310 x 90

+ -+ - + - + -
24V 24V PF Z1 Z2 Z3 MAN DISAB REL ACT HOLD EXTR MAN RS485 RS485
DC DC FIRE FIRE FIRE MODE REL OUT IN

PROCESSOR
RESET ADDRESS
MAN FUSE
Z1 Z2 Z3 MAN DISAB REL ACT REL EXTR HOLD OK FAIL

Example System Schematic

Hold
Manual Release
Door Interlock

Low Pressure Switch

Released Pressure Switch
2nd Stage Sounders

Activate Extinguisher
1st Stage Sounders

Detection Zone 3

Detection Zone 2

Detection Zone 1

System Status
and Control

4 Core

Ancillary
Board
EN12094-1 Approved Control Unit

System Status System Status

and Control and Control BMS
Addressable Interface
House Fire Alarm
4 Core

Ancillary
Board

Datasheet DS75/07/17
For further information visit www.kentec.co.uk
Kentec Electronics Ltd. reserves the right to alter the specification of its products from time to time without notice.
Although every effort has been made to ensure the accuracy of the information contained in this document it is not
warranted or represented by Kentec Electronics Ltd. to be a complete and up-to-date description.