Scribd
Upload
25 views2 pages

August 2014

This document contains a practice exam for a Digital Communication course. It includes 6 multiple choice questions across 3 units: 1) Questions 1 and 2 cover sampling theory and delta modulation. Question 1 asks about the sampling theorem and Nyquist rate for a given signal. Question 2 asks about the maximum amplitude of a test signal for a delta modulator. 2) Questions 3 and 4 cover digital multiplexing and scrambling. Question 3 asks about digital multiplexer categories and line codes. Question 4 asks about the output of a given scrambler circuit. 3) Questions 5 and 6 cover power spectral density and random processes. Question 5 asks about properties of power spectral density and if a given process is wide sense stationary

Uploaded by

pecoxor808
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
25 views2 pages

August 2014

This document contains a practice exam for a Digital Communication course. It includes 6 multiple choice questions across 3 units: 1) Questions 1 and 2 cover sampling theory and delta modulation. Question 1 asks about the sampling theorem and Nyquist rate for a given signal. Question 2 asks about the maximum amplitude of a test signal for a delta modulator. 2) Questions 3 and 4 cover digital multiplexing and scrambling. Question 3 asks about digital multiplexer categories and line codes. Question 4 asks about the output of a given scrambler circuit. 3) Questions 5 and 6 cover power spectral density and random processes. Question 5 asks about properties of power spectral density and if a given process is wide sense stationary

Uploaded by

pecoxor808
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Total No. of Questions : 6] SEAT No.

P3688 [Total No. of Pages :2


Engg. - 26
T.E (E & TC) (Semester-I)
Digital Communication (In Sem.)
(2012 Pattern)
Time :1 Hour] [Max. Marks :30
Instructions to the candidates :
1) Answer Q1 or Q2, Q3 or Q4, Q5 or Q6
2) Neat diagrams must be drawn wherever necessary.
3) Figures to the right side indicate full marks.

UNIT-I

Q1) a) State Sampling Theorem. Find the Nyquist Rate and Interval for the
given signal X(t)= sinc(l00 π t) + sinc (50 π t) [4]

b) A linear delta modulator is designed to operate on speech signals limited


to 3.6 kHz and which is sampled at a rate of 10 times the Nyquist rate.
Step size is 100 mV. The modulator is tested with a 1 kHz sinusoidal
signal. Determine the maximum amplitude of this test signal required to
avoid slope overload. [6]

OR

Q2) a) Explain the working of LPC speech coder with the help of block
schematic. [4]

b) A television signal has a bandwidth of 4.5MHz. This signal is sampled,


quantized and binary coded to obtain a PCM signal. [6]

i) Determine the sampling rate if the signal is to be sampled at a rate


above the Nyquist rate.

ii) If the samples are quantized into 1024 levels determine the number
of binary pulses required to encode each sample.

iii) Determine the bit rate and minimum bandwidth required to transmit
this signal.

P.T.O.
UNIT-II

Q3) a) Explain the broad categories of digital multiplexers. [4]

b) Given the data stream 11000101, sketch the transmitted sequence of


pulses for each of the following line codes and compare performance
parameters of these codes [6]
i) AMI-RZ
ii) Split Phase ( Manchester)

OR

Q4) a) The data stream of [11111] is given to a scrambler shown below. Determine
the output sequence of a scrambler. Assume initial contents of the registers
to be zero. [4]

b) What do you understand by ISI and state Nyquist First Criterion for
Zero ISI. [6]

UNIT-III

Q5) a) State any four properties of Power Spectral Density. [4]

b) Show that the random process


x(t)=A cos (wct + θ )
is a Wide Sense Stationary Process, where θ is a RV which is uniformly
distributed in the range (0, 2 π ). [6]
OR
Q6) a) Define the following terms:
i) Autocorrelation Function
ii) Autocovariance Function [4]

b) Explain the procedure to represent narrowband noise in terms of in-


phase and quadrature components. [6]

hhh
[Engg.] - 26 2

You might also like