Scribd
Upload
24 views

Computer Networks

This document contains 8 questions for an assignment on computer networks. The questions cover topics like bandwidth calculations, switching techniques, network architecture design, data transmission rates, error detection, and flow control frame sizes.

Uploaded by

ayush kaul
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
24 views

Computer Networks

This document contains 8 questions for an assignment on computer networks. The questions cover topics like bandwidth calculations, switching techniques, network architecture design, data transmission rates, error detection, and flow control frame sizes.

Uploaded by

ayush kaul
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

DEPARTMENT OF COMPUTER SCIENCE AND ENGINEERING

COMPUTER NETWORKS
CODE: CIC‐307
Last Date of Submission: 29th September 2023
ASSIGNMENT-1
Q.1 Calculate the minimum bandwidth (in Hz) required for a digital signal that uses 8-level amplitude
modulation to transmit data at 10 Mbps. Assume a signal-to-noise ratio (SNR) of 30 dB. [CO4]

Q.2 Compare space-division, time-division, and space-time division circuit switching techniques in terms
of resource utilization and scalability. [CO2]

Q.3 Design a comprehensive network architecture for a large university campus, including addressing,
transmission media choices, and switching technologies. Justify your design decisions based on the
specific requirements of a university environment. [CO3]

Q.4 A noiseless 4-kHz channel is sampled every 1 msec. What is the maximum data rate? How does the
maximum data rate change if the channel is noisy, with a signal-to-noise ratio of 30 dB? [CO4]

Q.5 A sliding window protocol is implemented over a noisy channel. If the sender's window size is 4 and
the receiver's window size is 5, calculate the maximum number of unacknowledged frames that can be in
transit without causing a deadlock. [CO4]
Q.6 A bit stream 10011101 is transmitted using the standard CRC method. The generator polynomial is
x 3 + 1. Show the actual bit string transmitted. Suppose that the third bit from the left is inverted during
transmission. Show that this error is detected at the receiver’s end. Give an example of bit errors in the
bit string transmitted that will not be detected by the receiver. [CO4]
Q.7 You are given a data stream "110101101" and suspect it might contain errors. Implement a CRC-16
error detection scheme for this data stream and provide the resulting codeword. Show all steps in your
calculation. [CO4]

Q.8 Given a data transmission rate of 1 Mbps and a propagation delay of 50 ms, calculate the minimum
frame size for efficient flow control using the Stop-and-Wait ARQ protocol. Assume a link efficiency of
70%. Show your calculations. [CO4]

CSE Department, MAIT

You might also like