Scribd
Upload
426 views3 pages

Geotechnical Engineering Procedures For Foundation Design of Buildings and Structures

This 185-page document is a technical report on geotechnical engineering topics related to foundations, soils, and earthworks. It contains 11 chapters that cover selection of foundation types, shallow foundations, deep foundations, retaining walls, slope stability analysis, excavation and fill, backfill, soil stabilization techniques, dewatering, expansive soils, permafrost soils, vibratory equipment foundations, pile driving equipment, and grouting methods. Each chapter provides an introduction and breakdown of sub-topics with guidance on analysis, design, construction, and specifications.

Uploaded by

api-3723333
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
426 views3 pages

Geotechnical Engineering Procedures For Foundation Design of Buildings and Structures

This 185-page document is a technical report on geotechnical engineering topics related to foundations, soils, and earthworks. It contains 11 chapters that cover selection of foundation types, shallow foundations, deep foundations, retaining walls, slope stability analysis, excavation and fill, backfill, soil stabilization techniques, dewatering, expansive soils, permafrost soils, vibratory equipment foundations, pile driving equipment, and grouting methods. Each chapter provides an introduction and breakdown of sub-topics with guidance on analysis, design, construction, and specifications.

Uploaded by

api-3723333
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
You are on page 1/ 3

file : pdf, 185 pages

download : http://artikel-software.com/blog

chapter 1 introduction

1-1 purpose
1-2 scope
1-3 references
1-4 general guidance
1-4.1 content guidance

chapter 2 soils and geology

chapter 3 selection of foundation types

3-1 selection of foundation type


3-1.1 foundation selection consideration
3-1.2 adverse subsurface conditions
3-1.3 cost estimates and final selection

chapter 4 shallow foundations

chapter 5 deep foundations

chapter 6 retaining walls and cellular cofferdams

chapter 7 slope stability analysis

chapter 8 excavation, fill, backfill, and soil stabilitization for structures

8-1 excavations
8-1.1 introduction and scope
8-1.2 open cuts 1
8-1.3 trenching
8-1.4 rock excavation
8-1.5 excavation stabilization, monitoring, and safety
8-1.6 embankment cross-section design
8-1.7 borrow excavaton
8-2 fill
8-2.1 types of fill
8-2.2 foundations on compacted fill
8-2.3 compaction requirements
8-2.4 placing and control of backfill
8-2.5 fill settlements
8-2.6 hydraulic fills
8-3 backfill
8-3.1 introduction
8-3.2 planning and design of structures and excavations to accommodate backfill
operations
8-3.3 evaluation, design, and processing of backfill materials
8-3.4 selection of backfill materials
8-3.5 processing of backfill materials
8-4 earthwork: excavation and preparation for foundations
8-4.1 excavation
8-4.2 foundation preparation
8-5 backfill operations
8-5.1 placement of backfill
8-5.2 good construction practices, and problems
8-5.3 special problems
8-5.4 installation of instruments
8-5.5 post construction distress
8-6 specification provisions
8-6.1 general
8-6.2 preparation of specifications
8-6.3 foundation preparation
8-6.4 backfill operations
8-7 stabilization of subgrade soils
8-7.1 general
8-7.2 vibrocompaction
8-7.3 vibrodisplacement compaction
8-7.4 grouting and injection
8-7.5 precompression
8-7.6 reinforcement
8-7.7 miscellaneous methods

chapter 9 dewatering and groundwater control

chapter 10 foundations in expansive soils

chapter 11 foundations in areas of significant front penetrat

11-1 introduction
11-1.1 types of areas
11-1.2 general nature of design problems
11-2 factors affecting design of foundations
11-2.1 physiography and geology
11-2.2 temperature
11-2.3 foundation materials
11-2.4 water conditions
11-2.5 frost heave and effect of surcharge
11-2.6 type pf structure
11-3 site investigations
11-3.1 general
11-3.2 remote sensing and geophysical investigations
11-3.3 direct site investigations
11-4 foundation design
11-4.1 selection of foundation type
11-4.2 foundation freeze and thaw and techniques for control ..
11-4.3 control of movement and distortion
11-4.4 vibration problems and seismic effects
11-4.5 design criteria for various specific features

chapter 12 foundations for vibrating equipement and seismic loadings

12-1 introduction
12-1.1 introduction
12-1.2 single degree of freedom, damped force systems
12-1.3 foundations on elastic soils
12-1.4 wave transmission, attenuation and isolation
12-1.5 evaluation of s-wave velocity in soils
12-1.6 settlement and liquefaction
12-1.7 seismic effects on foundations

chapter 13 pile driving equipment


chapter 14 grouting methods and equipment

You might also like