Scribd
Upload
701 views

Moshell Commands

This document lists various commands that can be used in the Moshell interface to check status and configuration information for network equipment. Some of the commands check alarm statuses, equipment statuses like RRUs and cells, VLAN configurations, IP addresses, hub positions, traffic levels, and port configurations. Other commands allow setting the hub position or port operating modes.

Uploaded by

xcvfvfd
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
701 views

Moshell Commands

This document lists various commands that can be used in the Moshell interface to check status and configuration information for network equipment. Some of the commands check alarm statuses, equipment statuses like RRUs and cells, VLAN configurations, IP addresses, hub positions, traffic levels, and port configurations. Other commands allow setting the hub position or port operating modes.

Uploaded by

xcvfvfd
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

MOSHELL COMMANDS

1. LOGIN :lt all


2. Alarm checking: alt
3. RRU status checking: st rru
4. Cell status checking: st cell
5. Hub position checking: get .hub
6. Board status checking&VSWR: cabx
7. Checking alarms on boards:invxr
8. Checking alarms: al
9. Check if site is carrying traffic: get radio no
10. Checking VLAN on BB:get.vid
11. Checking VLANS on BB: get . vlanid
12. Checking VLAN on DUW: get interface vid
13. Checking OAM ip on DUW:get iphostlink address
14. Checking hub position: get.hub
15. Setting hub position:
16. Get EC Port: get ecport
17. Set (Proxy number) hub position (free EC Port physical on SHU):
set..hubposition A.. or B..

18. To see how many line/s being used :getradiolinks

19. To check cell state in RBS:lst cell


20. To check trx on the Node:St trx:
21. get address address
22. get nexthop address
23. mcc address ping 10.161.14.220
24. hget ru productedata
25. st trx

26. set EthernetPort=TN_A admOperatingMode 5

You might also like