Scribd
Upload
89 views1 page

Template SRFW

This document provides a weld procedure specification for a single run fillet weld using the MAG welding process in the flat position. The weld will use an Xmm filler material with a current of XXX-XXX amps and a voltage of XX-XX volts. Welding details include a wire feed speed of X m/min and a travel speed of X mm/sec with a heat input of 0.XXX-0.XXX kJ/min. Post weld heat treatment is not required.

Uploaded by

Dylan Trigg
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
Download as docx, pdf, or txt
89 views1 page

Template SRFW

This document provides a weld procedure specification for a single run fillet weld using the MAG welding process in the flat position. The weld will use an Xmm filler material with a current of XXX-XXX amps and a voltage of XX-XX volts. Welding details include a wire feed speed of X m/min and a travel speed of X mm/sec with a heat input of 0.XXX-0.XXX kJ/min. Post weld heat treatment is not required.

Uploaded by

Dylan Trigg
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
Download as docx, pdf, or txt
Download as docx, pdf, or txt
You are on page 1/ 1

Company Name

LOGO Address Line 1


Address Line 2
Town, County
Postcode
Weld Procedure Specification (WPS)
Location: Workshop Joint Type: Single Run Fillet
Manufacturer’s WPS No: SRFW-WPS001 Method of Preparation: Light Grinding
WPQR: SRFW Parent Material Designation: BS EN 10025 S355JR
Manufacturer: Company Name Material Thickness: X to Xmm
Welders Name: Welders Name Outside Diameter: N/A
Welding Process: 135 (MAG) Welding Position: PA (Flat)

Joint Design Welding Sequence

Welding Details:

Size of Type of Wire Feed Travel Heat


Welding Welding Current Voltage Transfer
Run Filler Current/ Speed Speed Input
Process Direction A V Mode
Material Polarity M/min mm/sec KJ/min
1 MAG PA Xmm XXX - XXX XX - XX DC+ve X X 0.XXX – 0.XXX DIP

Filler Metal Classification & Trade Name EN 14341-A: G38 4M G3SI1 / G38 (Brand Name Wire)
Any Special Baking or Drying Stored in accordance with manufacturers recommendations.
Gas/Flux: - Shielding/Backing Gas retail name (ISO 14175 – M24 ArCO7/2.5
Shielding Gas Flow Rate 15L/Minute
Tungsten Electrode Type/Size NA
Details of Back Gouging/Backing NA
Preheat Temperature X℃
Interpass Temperature (℃) ‘Maximum recorded in WPQR’ (Note 4)
Post Weld Heat Treatment NA
Time, Temperature, Method NA
Heating & Cooling Rates NA
Other Information 1: Nozzle diameter = Xmm
2: In all cases the gap between component parts shall be kept to a minimum
3: Actual run sequence will depend on the thickness of the parent material
4: Interpass temperature shall be checked using infrared thermometer
5: Weld finish to be left as-welded unless specified otherwise
6: Weaving Xmm
7: Torch angle X°

RWC Signature:

Key:
NA = Not Applicable G = Globular S = Spray

You might also like