DOPAK® Process Sampler Type S32-LG
system purge configuration (F1)
The ability to purge the sample point ensures optimal retrieval of
a representative, contamination free sample. The S32-LG type
samplers provide a system purge in addition to sampling in a
sample cylinder with a predefined filling rate. The predefined
filling rate is achieved by using an expansion chamber.
The unique design offers a one handle operation by multiple
valves. These features provide sample accuracy and safety.
This sampler type is suitable for liquefied gases and liquids.
1 OPERATION/FUNCTION
0 - off 1 - system purge
Install the sample cylinder and Turn the handle to the “process”
connect the flexible hose to position, allowing the sample
the bottom side of the sample cylinder to be filled. To ensure
cylinder. Open the needle valves representative sampling, this
of the sample cylinder. position can be held for any
required time.
2 - expansion 3 - vent
Turn the handle to the “expansion” Open the valve on the expansion
position. The internal connection chamber. The expansion chamber
between the sample cylinder and and connections are being
the expansion chamber has now depressurised to the vent system.
been made. Maintain this position Release the handle to close the
for any required time to enable the valve.
fluid to divide over the sample
cylinder and expansion chamber.
Close the two needle valves of the
sample cylinder.
2 TYPICAL P & ID 4 - off
Turn the handle to the “off”
position. Disconnect the
flexible hose. Remove the
sample cylinder and connect
PI the flexible hose to the top
PROCESS OUT quick connect coupling.
PROCESS IN
VENT
system purge configuration (F1)
3 FEATURES/ADVANTAGES/PROPERTIES
Sampling in cylinder with predefined filling rate One-handle operation of mutiple valves
Representative sampling Purging of sampler
Zero dead volume No direct connection between vent line
Closed sampling and process lines
Depressurissation of quick connect couplings
No outage tube needed
4 BASIC SPECIFICATIONS
Material SS316, SS316L.
Cylinder Type 500cc cylinder.
Expansion Chamber 100cc (20% of sample volume).
Valve Three-way ball valve type W83. PTFE seats, Viton A O-rings.
Pressure range 103 bar @ 20°C (1500 psig @ 70°F).
Temperature range -17/+232°C (0/+450°F).
Operation Manual.
Connections 1/4ll FNPT. Regulator, pressure gauge and check valve included.
Please note: the above is a basic specification only. DOPAK® Samplers can be
offered with a wide variety of options as mentioned below.
5 OPTIONS
Spring return handle Enclosure
Lockable handle Sample cooler
Pipe stand Exotic materials
Block valve Larger/smaller sample size
Flow meter
For more information please refer to our sheets:
Options for DOPAK® process sampler, sampling into a cylinder.
Components for DOPAK® process samplers.
Dopak Inc. Dovianus BV Your local representative:
Houston, Texas 77041, USA Bergschenhoek, The Netherlands
Phone 713-460-8311 Phone +31 10 524 20 00
E127E-1216
Fax 713-460-8578 Fax +31 10 524 20 29
E-mail
[email protected] E-mail
[email protected]
