Water Unit Control System
Water Unit Control System
Volume 8, Issue 7, July – 2023 International Journal of Innovative Science and Research Technology
ISSN No:-2456-2165
Water Unit Control System
Amit Kumar Gupta1, Rishabh Kumar2, Sonali3, KM. Cheshta4, Mohd Hannan5
Electronics and Communication EngineeringShri Ram Group of Colleges, Muzaffarnagar
Abstract:- A smart water measuring system has been II. METHODOLOGY
designed and constructed to get the desired volume of
water from the storage. This can be mainly used for In this project we research and go through that what
industrial, beverage industries laboratory purposes, in are the components which is necessary for the development
large scale industries, house tank etc. of the project are DC water pump(5-12volt), I2C Module,
LCD Display, Water Flow Sensor, Relay, 4*3 Matrix
Our project takes over the task of manual filling of Keypad, Arduino UNO, Water Tap, Fluid pipe, Male
liquid in small industries, laboratories. There by Female Jumper Wires.
reducing the chances of human errors and wastage of
any liquid due to spill or overflow. The our project is also Here we use Arduino UNO, which is low-cost general-
giving these benefits – purpose microcontroller running on atmega328p Chip.
We can get the exact volume of the liquid as needed. In this water level controller will use mainly two
Saving in water cost and energy conservation. This components the water flow sensor and relay module. The
circuit finds wide applications in our industries. The motor to turn off and on needs to be specified. There is a
primary objective of our system is to develop a program that executes the sensor via Arduino uno. Through
user- f r i e n d l y system and the second objectives relay we will start the whole process of this project; relay
is to design the system to minimize the worker and states that switching process of this project.
operation cost.
We use Arduino Uno and water flow sensor the sensor
Keywords:- Microcontroller, Water Flow Sensors, Relay, can be used for the count of water flow rate and using flow
16*2 LCD , 4*3 Keypad, Water pump, I2C Module rate of water flow sensor we can easily calculate the amount
of the water, it is a simple sensor that tells the amount of
I. INTRODUCTION water by using some calculation of flow rate which is
written below
The earth’s surface is covered 71 % of water. Water is
vital for all living things on the earth. Though the rate of Flow Rate = ((1000.0 / (millis () - oldTime)) * pulseCount)
population growth will greatly affect the increasing need for / calibrationFactor
clean water. One effort to prevent water vulnerability is to
save water using water unit controller system. A water Later, the Arduino Uno interprets as some digital
unit controller system is a type of system that is used to value, and 16* 2 LCD displays the amount of water and the
automatically fill water containers, such as tanks, reservoirs, flow rate of water on screen which can be done using
or bottles. This study aims to develop Water unit controller Arduino Uno command and programming the point to be
or Water unit controller using matrix keyboard to get the noted here is that, we need to download LiquidcrystalI2C.h
desired volume of water from the storage. This system can for 16*2 LCD display, Keypad.h for keypad functioning and
be used in various applications such as industrial, wire.h for the I2C protocol communication, library file for
agriculture and domestic use. There by reducing the chances Arduino IDE to execute these. The motor is also given
of human errors and wastage of water and any liquid due to manual control, when the water level is full, it will be stop
spill or overflow. automatically. The motor is turned on via a relay, the motor
also stops pumping whenever the water level reaches the
same amount of water which is showed on LCD display less
manpower required. If the industry can produce the product
within the required range, then the demand of the product
will be increased. So, the company will be benefited.
III. RESULT
Every day, we waste water in our homes, restaurant,
hotels etc. as well. Our finding is helpful to better
understand the development process of water – saving
standards. We have successfully completed our project. The
water controller provided desired volume of the water. In
Fig 1 Circuit of Smart Measuring System result analysis we after uploading the code to the Arduino
IJISRT23JUL1905 www.ijisrt.com 2123
Volume 8, Issue 7, July – 2023 International Journal of Innovative Science and Research Technology
ISSN No:-2456-2165
uno board, the project is ready for testing. Power the supply
entire circuit with supply or using USB port of Arduino
uno.
The set volume option appears on the LCD screen. We
need to input the water quantity using the 4x3 matrix
keypad. After entering the volume, press the start button the
water will start dispersing. Once the filling is done, the relay
disconnects the water pump, and hence the water dispersing
is stops. The water controller project has a lot of
applications in industries.
IV. CONCLUSION
The water controller or water controller using matrix
keypad concept was successfully implemented and studied
various observations were taken which closely resembled
the actual volume to be filled. The water controller system
was beneficial in reducing the wastage of water, time, and
work. The fabricated model of water controller using matrix
keypad can be used where high precision is not necessary
and time limits not bound. Hence it must be used application
and it is mainly used in industries for filling large amount of
liquids.
We have successfully achieved our objective that is
water controller using matrix keypad.
REFERENCES
[1]. https://www.exportersindia.com/indian-
suppliers/mineral-water-filling- machine.htm
[2]. https://www.drofen- pharma.com/pharmaceutical-
filling- machine/syringe-filling-machine/pfs- filling-
machine. html?gclid=EAIaIQobChMIso-
e_9nj_gIV9ZJmAh2BPQItEAMYAiAAE
gI4VPD_BwE
[3]. https://www.trentonsystems.com/blog/wh at-is-a-heat
sink
[4]. Arduino Uno - Wikipedia
