BI-DIRECTIONAL METER CT SENSOR
M
250AT 2P
ATS
2 LONGI SOLAR PANEL 3 ELECTRICAL NOTES
E1 E1
MODULE NUMBER LR5-72HTH-600M
RATED MAXIMUM POWER 600W
1 SINGLE LINE DIAGRAM 250AT 2P
CURRENT AT PMAX 13.44A 1. ALL ELECTRICAL WORKS INDICATED SHALL BE DONE 3. ALL INSTALLATION SHALL BE DONE IN GOOD
VOLTAGE AT PMAX 44.66 V IN ACCORDANCE WITH THE LATEST PROVISION OF AND NEAT WORKMANSHIP.
E1 2-30mm sq THHN 2-80mm sq THHN SHORT CIRCUIT CURRENT 14.46A
THE PHILIPPINES ELECTRICAL CODE RULES AND
REGULATION.
4. ALL ELECTRICAL WORKS SHALL BE DONE
CU in 32mm RSC CU in 65mm RSC OPEN CIRCUIT VOLTAGE 52.81 V UNDER THE DIRECT SUPERVISION OF
2. ALL MATERIALS TO BE USED SHALL BE NEW AND PROFESSIONAL ELECTRICAL / REGISTERED
APPROVED TYPE FOR ALL LOCATION AND ELECTRICAL ENGINEER OR MASTER
REC METER M PURPOSES. ELECTRICIAN.
100AT 2P 200AT 2P
10X 600Watts MONO Crystaline Solar Panel in Series Connection (STRING 2 )
3.5 mm sq
4 16KW DEYE HYBRID INVERTER 5 SOLAR ELECTRICAL NOTES
THW (G)
E1 E1
1. UTILITY HAS 24HRS UNRESTRICTED ACCESS 6. TAPPING POINT OF REC METER LOAD SIDE
TO ALL PV SYSTEM COMPONENTS LOCATED CONDUCTORS SHALL BE AT THE LOAD VISIBLE,
AT SERVICE ENTRANCE. DISCONNECT DEVICE BEFORE SERVICE
10X 600Watts MONO Crystaline Solar Panel in Series Connection (STRING 1 ) EQUIPMENT, REC METERS LOAD SIDE
2. MODULES CONFORM TO AND ARE
Model No. SUN-16K-SG01LP1-EU LISTED UNDER UL 1703 CONDUCTORS SHOULD BE SHORT AS POSSIBLE
3.5 mm sq
Battery Input Data
3. CONDUCTORS EXPOSED TO SUNLIGHT 7. THE LINE SIDE CONDUCTORS OF THE REC
THW (G) Battery Type Lead-acid or Lithium-ion
SHALL BE LISTED AS SUNLIGHT METER BETWEEN THE GRID TIE INVERTER
Battery Voltage Range (V) 40~60V
RESISTANCE AS PER PEC REC METERS SHALL BE AN EXPOSED RIGID
Max. Charging Current (A) 220A
2-22mm sq METALLIC CONDUIT OR INTERMEDIATE
THHN CU in Max. Discharging Current (A) 220A 4. CONDUCTORS EXPOSED TO WET METALLIC CONDUIT.
25mm RSC UPS Power (W) 16000 LOCATION SHALL BE SUITABLE FOR USE
Charging Curve 3 Stages / Equalization WET LOCATION AS PER PEC 8. WARNING SHOULD BE MOUNTED ON
2-4mm sq DC Wire in 20 mm External Temperature Sensor Yes OR ADJACENT TO THE VISIBLE
5. NEW REC METER SHALL BE
2-22mm sq
16KW Charging Strategy for Li-Ion Battery Self-adaption to BMS
INSTALLED NEAR TO NEW BI
DISCONNECTION DEVICE AND SHALL
BE READ PROMINENTLY.
THHN CU in
25mm RSC
HYBRID PV String Input Data DIRECTIONAL METER
Input Data(DC)
INVERTER
SOLAR PANEL PER STRING Max. DC Power
Max. DC Voltage
20.8 kW
500 V
Rated DC Voltage 370 V
Min. DC Voltage to Start Feed In 150 V
ISC = (14.46A) X 1.25 = 18.08A
USE : 20AT DC BREAKER ,700V 20kA SPD Max. DC Current 132 A 6 SCHEDULE OF LOADS
2-4mm sq DC Wire in 20 mm sq MPP(T) Voltage Range 150~425 V
Liquitight Conduit or uPVC No of MPP Trackers 3 E1
DC Inputs 6
Cable Loss:
Output Data (AC)
Ppv_cable = 2*3.39ohms/km*0.02km*(13.44)²
Nominal AC Voltage 220, 230 V
Ppv_cable = 24.49W (Per String)
Rated AC Current 69.6 A
Frequency 50, 60 Hz
Ppv_input = Ppv_peak - Ppv_cable No of feed-in phases 1
Ppv_input = 600*10*1.03*0.912 - 24.49 Max. Efficiency 97.6 %
Ppv_input = 5611.67W (Per String) Euro Efficiency 96.5 %
Vpv_input = 44.66*10units
Vpv_input = 446.6V (Per String)
Voltage Drop:
Vdrop_cable = 2*3.39ohms/km*0.02km*13.44A 2 x 200AH
Vdrop_cable = 1.82V (Per String ) 51.2V
LIFEPO4
INVERTER DC SPD DC SPD AC SPD
BATTERY
PMAX = 16000W / 230V = 69.57A
USE : 75 AT AC BREAKER
2-22 mm sq THHN Cu Wire in 25mm RSC/IMC
BATTERY PROTECTION 8 SERVICE ENTRANCE
USE : 125 AT DC BREAKER PER BATTERY
E1
2-38mm sq DC Wire SERVICE ENTRANCE
TO INVERTER
7 LEGEND REC METER BI- DIRECTIONAL
E1 METER BASE
SERVICE EQUIPMENT
5FT
SERVICE REC METER / BI M AC / DC BREAKER
ENTRANCE DIRECTIONAL
METER
CT SENSOR
SOLAR PANEL ON
SOLAR
INVERTER AC / DC ISOLATOR
OFF
INVERTER
SURGE GROUND ROD
SURGE PROTECTION
PROTECTION DEVICE AC
DEVICE DC
12KWP HYBRID SOLAR PHOTOVOLTAIC SYSTEM
AS SHOWN 1
