Scribd
Upload
34 views

Assignment - 2 EECE2315

This document contains 12 problems related to engineering electromagnetics: 1) Finding the total charge on a circular disk with a given charge density distribution. 2) Finding the electric field for a given electric potential. 3) Stating the boundary conditions for electric and magnetic fields at interfaces. 4) Finding the electric field experienced by an electron with a given velocity in a magnetic field.

Uploaded by

Izwan Fazry
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
34 views

Assignment - 2 EECE2315

This document contains 12 problems related to engineering electromagnetics: 1) Finding the total charge on a circular disk with a given charge density distribution. 2) Finding the electric field for a given electric potential. 3) Stating the boundary conditions for electric and magnetic fields at interfaces. 4) Finding the electric field experienced by an electron with a given velocity in a magnetic field.

Uploaded by

Izwan Fazry
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

EECE 2315 Engineering Electromagnetics – Assignment #2

1) Find the total charge on a circular disk defined by 𝑟 ≤ 𝑎 and 𝑧 = 0 if 𝜌𝑠 = 𝜌𝑠0 𝑠𝑖𝑛2 ∅ [𝐶⁄ 2 ],
𝑚
where 𝜌𝑠0 is a constant.

10
2) Find the electric field 𝑬 for the electric potential given by 𝑉 = sin 𝜃 cos ∅.
𝑟2

3) State the boundary conditions for electric field and magnetic field in terms of the tangential and
normal components (statements and equations).

4) An electron with velocity 𝒖 = (4𝒙 ̂ + 3𝒛̂) × 105 [𝑚⁄𝑠] experiences no net force at a point
̂ − 12𝒚
̂ + 20𝒛̂ [𝑚𝑇]. Find 𝑬 at that point.
̂ + 10𝒚
in magnetic flux 𝑩 = 30𝒙

5) Find the magnetic field 𝑯 at the center (point 𝑃 (0, 0, 0)) of a square loop conductor with current
𝐼 as shown in Fig. 5 below. Each side is of the square 40 𝑐𝑚 in length, and the conductor carries
a current of 5𝐴 in clockwise direction when the loop is viewed from top side.

Fig. 5
6) Determine the magnetic field intensity 𝑯 at point 𝑃 of the two half-circle current carrying
conductor shown in figure below.

Fig. 6

̂ 5 cos 𝜋𝑦 + 𝒛̂ (2 + sin 𝜋𝑥 ) [𝑊𝑏/𝑚]. Find the


7) Given that the vector magnetic potential is 𝑨 = 𝒙
magnetic flux density 𝑩.

8) A coil consists of 10 turns of wire wrapped around a square frame of sides 0.25 m. The coil is
centered at the origin with each of its sides parallel to 𝑥-𝑦 axis. Find the induced emf across the
open circuited ends of the coil if the magnetic flux density is given as ⃗𝑩
⃗ = 𝒛̂ 10 𝑒 −2𝑡 [𝑇].

9) A long straight co-axial cable lying along the z-axis is carrying current 𝐼 [𝐴] in the inner conductor
and current −𝐼[𝐴] in the outer conductor. The cross section of the cable with all dimensions is
shown in figure on the right. Find the magnetic field 𝑯 as a function of distance from the center
𝑟 of the following:
𝐼 [𝐴]
i. 0≤𝑟≤𝑎
ii. 𝑎≤𝑟≤𝑏
iii. 𝑏≤𝑟≤𝑐
iv. 𝑟≥𝑐
−𝐼 [𝐴]

Fig. 9
10) Fig. 10 below shows a stationary conducting loop of radius 𝑎 is placed in a time-varying
magnetic field 𝑩 = 𝒛̂𝐵0 sin 𝜔𝑡. Find the transformer emf given that 𝑁 = 1, 𝐵0 = 0.2 𝑇, 𝑎 =
15 𝑐𝑚, and 𝜔 = 103 𝑟𝑎𝑑𝑠⁄𝑠.

Fig. 10

11) A 50 𝑐𝑚 long metal rod rotates about the 𝑧-axis at 90 revolutions per minute, with end 1 fixed
at the origin as shown in fig. 11 below. Determine the induced emf 𝑉12 if 𝑩 = 𝒛̂2 × 10−4 [𝑇].

Fig. 11

̂ 𝑟𝜔
Hint: change “revolutions per minute” to rad/s (𝜔) first. Velocity of the bar is given by 𝒖 = ∅

12) A coaxial capacitor of l = 6 cm uses an insulating dielectric material with 𝜀𝑟 = 9. The radius of the
cylinders are 0.5 cm and 1 cm. If the voltage applied across the capacitor is
𝑉 (𝑡) = 50 𝑠𝑖𝑛 (120𝑡) [𝑉],
calculate the displacement current, 𝐼𝑑 .

You might also like