MATERIAL SAFETY DATA SHEET
TECHNOWRAP 2K™ RESIN PART A
1. IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND THE
COMPANY/UNDERTAKING
TM
PRODUCT NAME: TECHNOWRAP 2K
PART NO:
APPLICATIONS:
SUPPLIER: WALKER TECHNICAL RESOURCES LTD
TEL: +44 (0) 1224 822822
FAX: +44 (0) 1224 822299
E-MAIL: [email protected]
DATE ISSUED: 060109
2. HAZARDS IDENTIFICATION
May cause sensitisation by skin contact. Irritating to eyes and skin. Toxic to aquatic organisms, may cause long-
term adverse effects in the aquatic environment.
CLASSIFICATION: Xi;R36/38. R43. N;R51/53.
3. COMPOSITION/INFORMATION ON INGREDIENTS
NAME EC NO. CAS- NO. CONTENT CLASSIFICATION
EPOXY RESIN (Number 500-033-5 25068-38- 60-100% R43 XI;R36/38 N;R51/53
average MW <= 700) 6
The full text for all R-phrases are shown in section 16
4. FIRST AID MEASURES
INHALATION: Move the exposed person to fresh air at once. Get medical attention if any
discomfort continues.
INGESTION: Do not induce vomiting. Immediately rinse mouth and drink plenty of water (200-
300 ml). Get medical attention.
SKIN CONTACT: Remove contaminated clothing immediately and wash skin with soap and water.
Get medical attention if irritation persists after washing.
EYE CONTACT: Promptly wash eyes with plenty of water while lifting the eye lids. Continue to
rinse for at least 15 minutes. Get medical attention if any discomfort continues.
W28-16
MATERIAL SAFETY DATA SHEET
TECHNOWRAP 2K™ RESIN PART A
5. FIRE FIGHTING MEASURES
EXTINGUISHING MEDIA: Carbon dioxide (CO2). Dry chemicals, sand, dolomite etc. Foam. DO NOT use
water if avoidable.
SPECIAL FIRE FIGHTING Move container from fire area if it can be done without risk. Water spray should
PROCEDURES: be used to cool containers. Cool containers exposed to flames with water until
well after the fire is out. Keep run-off water out of sewers and water sources.
Dike for water control.
SPECIFIC HAZARDS: In case of fire, toxic gases may be formed. Fire creates: Carbon monoxide (CO).
Carbon dioxide (CO2).
PROTECTIVE MEASURES IN Use protective equipment appropriate for surrounding materials. Self contained
FIRE: breathing apparatus and full protective clothing must be worn in case of fire.
6. ACCIDENTAL RELEASE MEASURES
PERSONAL PROTECTIONS: Use protective gloves, goggles and suitable protective clothing. Avoid inhalation
of vapours and contact with skin and eyes. Provide adequate ventilation. In
case of spills, beware of slippery floors and surfaces.
ENVIRONMENTAL Avoid release to the environment. Do not discharge into drains, water courses
PRECAUTIONS: or onto the ground. Contain spillages with sand, earth or any suitable adsorbent
material. The product should not be dumped in nature but collected and
delivered according to agreement with the local
authorities.
SPILL CLEAN-UP METHODS: Wear necessary protective equipment. Stop leak if possible without risk. Absorb
in vermiculite, dry sand or earth and place into containers. Containers with
collected spillage must be properly labelled with correct contents and hazard
symbol. Runoff or release to sewer, waterway or ground is forbidden. Flush area
clean with lots of water. Be aware of potential for surfaces to become slippery.
7. HANDLING AND STORAGE
USAGE PRECAUTIONS: Avoid spilling, skin and eye contact. Keep away from heat, sparks and open flame.
Do not eat, drink or smoke when using the product. Avoid inhalation of vapours.
STORAGE PRECAUTIONS: Store in tightly closed original container in a cool, dry well-ventilated place. 10 - 30
*C Keep away from heat, sparks and open flame. Keep separate from food,
feedstuffs, fertilisers and other sensitive material. Protect from light, including
direct sunrays. Store separated from: Acids. Alkalies. Oxidising material.
STORAGE CLASS: Chemical storage.
W28-16
MATERIAL SAFETY DATA SHEET
TECHNOWRAP 2K™ RESIN PART A
8. EXPOSURE CONTROLS AND PERSONAL PROTECTION
PROTECTIVE EQUIPMENT:
PROCESS CONDITIONS: Provide eyewash station.
ENGINEERING MEASURES: Provide adequate general and local exhaust ventilation.
RESPIRATORY EQUIPMENT: No specific recommendation made, but respiratory protection may still be required
under exceptional circumstances when excessive air contamination exists.
HAND PROTECTION: Use protective gloves. The most suitable glove must be chosen in consultation
with the gloves supplier, who can inform about the breakthrough time of the glove
material.
EYE PROTECTION: Wear splash-proof eye goggles to prevent any possibility of eye contact.
HYGIENE MESURES: Wash at the end of each work shift and before eating, smoking and using the toilet.
Wash promptly with soap & water if skin becomes contaminated. When using do
not eat, drink or smoke.
SKIN PROTECTION: Wear apron or protective clothing in case of splashes.
9. PHYSICAL AND CHEMICAL PROPERTIES
APPEARANCE: Liquid
COLOUR: Light (or pale) yellow
ODOUR: Mild
SOLUBILITY: Slightly soluble in water.
O
BOILING POINT/RANGE( C) >204
VAPOUR PRESSURE: 0.01 RELATVITY DENSITY: 1.16 20
O
FLASH POINT ( C) 177 PH-VALUE, CONC. SOLUTION:
10. STABILITY AND REACTIVITY
STABILITY: Stable under normal temperature conditions and recommended use.
CONDITIONS TO AVOID: Avoid heat, flames and other sources of ignition.
MATERIALS TO AVOID: Strong acids. Strong alkalies. Strong oxidising substances.
HAZARDOUS In case of fire, toxic gases may be formed. Fire creates: Carbon monoxide (CO).
DECOMPOSITION PRODUCTS: Carbon dioxide (CO2).
W28-16
MATERIAL SAFETY DATA SHEET
TECHNOWRAP 2K™ RESIN PART A
11. TOXICOLOGICAL INFORMATION
INHALATION: Not relevant at normal room temperatures. When heated, irritating vapours may be
formed.
INGESTION: May cause discomfort if swallowed.
SKIN CONTACT: Irritating to skin. May cause sensitisation by skin contact. May cause skin
irritation/eczema
EYE CONTACT: Irritating to eyes.
ROUTE OF ENTRY: Skin and/or eye contact.
TARGET ORGANS: Skin. Eyes.
MEDICAL SYMPTOMS: Upper respiratory irritation. Skin irritation. Skin contact may cause: Allergic rash.
Eye contact may cause: Irritation of eyes and mucous membranes. May cause
discomfort if swallowed.
MEDICAL CONSIDERATIONS: Skin disorders and allergies. Persons with rash are directed to skin expert for
examination of allergic eczema.
12. ECOLOGICAL INFORMATION
ECOTOXICITY: The product contains a substance which is toxic to aquatic organisms and which
may cause long term adverse effects in the aquatic environment.
BIOACCUMULATION: No data available on bioaccumulation.
DEGRADABILITY: No data available.
13. DISPOSAL CONSIDERATIONS
DISPOSAL METHODS: Do not allow runoff to sewer, waterway or ground. Dispose of waste and residues
in accordance with local authority requirements.
14. TRANSPORT INFORMATION
LABEL (S) FOR CONVEYANCE:
UK ROAD CLASS: CLASS 9
PROPER SHIPPING NAME: ENVIRONMENTALLY HAZARDOUS SUBSTANCE, LIQUID, N.O.S. (EPOXY
RESIN (Number average
MW <= 700 ))
UN NO ROAD: UN3082 UK ROAD PACK GR. III
ADR CLASS NO: 9 ADR CLASS: Class 9: Miscellaneous
W28-16
MATERIAL SAFETY DATA SHEET
TECHNOWRAP 2K™ RESIN PART A
dangerous substances and
articles.
ADR PACK GROUP: III HAZARD NO: (ADR): 90
ADR LABEL NO: 9 HAZCHEM CODE:: 3Z
CEFIC TEC@NO: 90GM6-III RID CLASS NO: 9
RID PACK GROUP: III UN NO SEA: UN3082
IMDG CLASS: 9 EMS: F-A, S-F
MFAG: See Guide MARINE POLLUTANT: No
UN NO AIR: UN3082 ICAO CLASS: 9
AIR PACKAGE GR: III
15. REGULATORY INFORMATION
LABELLING:
Irritant Dangerous for the Environment
CONTAINS: CONTAINS EPOXY RESIN (NUMBER AVERAGE MW <= 700)
RISK R43 May cause sensitisation by skin contact.
PHRASES:
R36/38 Irritating to eyes and skin.
R51/53 Toxic to aquatic organisms, may cause long-term adverse effects in the aquatic
environment.
SAFETY S24/25 Avoid contact with skin and eyes.
PHRASES:
S26 In case of contact with eyes, rinse immediately with plenty of water and seek
medical
advice.
S36/37/39 Wear suitable protective clothing, gloves and eye/face protection.
S60 This material and its container must be disposed of as hazardous waste.
P5 Contains epoxy constituents. See information supplied by the manufacturer.
UK REGULATORY Health and Safety at Work Act 1974.
REFERENCES:
EU DIRECTIVES: System of specific information relating to Dangerous Preparations. 2001/58/EEC.
Dangerous Substance Directive 67/548/EEC as amended. Dangerous
Preparations Directive 1999/45/EEC.
STATUTORY INSTRUMENTS: Chemicals (Hazard Information and Packaging for Supply) Regulations 2002 (SI
1689)
APPROVED CODE OF Control of Substances Hazardous to Health Regulations 2002.
PRACTICE:
GUIDANCE NOTES: Workplace Exposure Limits EH40.
W28-16
MATERIAL SAFETY DATA SHEET
TECHNOWRAP 2K™ RESIN PART A
16. OTHER INFORMATION
REVISION DATE: 10/08/10
REV. NO./REPL. SDS
GENERATED:
SDS No: 10521
SAFETY DATA SHEET Approved
STATUS:
R-PHRASES IN R36/38 Irritating to eyes and skin.
FULL:
R43 May cause sensitisation by skin contact
R51/53 Toxic to aquatic organisms, may cause long-term adverse effects in the aquatic
environment.
DISCLAIMER
THIS INFORMATION RELATES ONLY TO THE SPECIFIC MATERIAL DESIGNATED AND MAY NOT BE VALID FOR SUCH MATERIAL USED IN COMBINATION
WITH ANY OTHER MATERIALS OR IN ANY PROCESS. SUCH INFORMATION IS, TO THE BEST OF THE COMPANY’S KNOWLEDGE AND BELIEF, ACCURATE
AND RELIABLE AS OF THE DATE INDICATED. HOWEVER, NO WARRANTY, GUARANTEE OR REPRESENTATION IS MADE AS TO ITS ACCURACY,
RELIABILITY OR COMPLETENESS. IT IS THE USER’S RESPONSIBILITY TO SATISFY HIMSELF AS TO THE SUITABILITY OF SUCH INFORMATION FOR HIS
OWN PARTICULAR USE.
W28-16
