Assignment: SESSION-2019-20 SEM-6 (ODD)
Assignment: SESSION-2019-20 SEM-6 (ODD)
ASSIGNMENT
SEM-6TH (ODD)
UNIT-3
ASSIGNMENT SHEET NO. 1
ASSIGNMENT
SEM-6TH (ODD)
UNIT-3
ASSIGNMENT SHEET NO. 2
1. Describe with appropriate sketch, a 2phase 8/4 pole permanent magnet stepping
motor. For this motor determine the step angle and the excitation sequence of the
2 phase winding for clockwise an anticlockwise rotation of the rotor.
2. Explain working, construction and control of a Single-stack variable reluctance
stepper motor.
3. Explain working, construction and control of a multi-stack variable reluctance
stepper motor.
4. Explain the torque vs stepping rate characteristics of a stepper motor. What is
slew range?
5. Describe an efficient uni-polar drive for stepper motor.
6. Enumerate the features that the drive circuit for a stepping motor should possess
for optimum torque output. also describe the drive circuit used for VR and hybrid
stepping motors.
7. Explain the construction and principle of operation of a switched reluctance
motor.
8. Describe the inverter drive circuit used for switched reluctance motors. A three
phase 6/8 VRM is running at a speed of 1000 rpm. Calculate the time between
pulses required to excite the phase winding.
9. Explain the principle of operation of 6/4 pole variable reluctance stepper motor.
What is the motor torque required to accelerate the initial load of 10 -4/gm2 from
ω1=200 and ω2=300 rad/sec. Frictional load torque is 0.06 N-m.