1

5th lecture Exam

1. To effectively monitor any process, the initial phase the values are used to evaluate …….
A the process Mean and Standard Deviation
B the process Median
C the process Mode
D All of the above
2. During this control phase, we need to
A Monitor any points that moving out of control
B Identify the special cause for variation
C Try to eliminate those causes to make the process in control
D All of the above
3. Which of the following scenarios is best suited to use an X-bar and R chart?
A A smaller sample size is needed
B It is necessary to know when to investigate a process for causes of variation
C The machine capability is wider than the specification
D An acceptable quality level must be established
4. During this control phase generally good to collect data in subgroups, if possible, But sometimes
gathering subgroups of measurements isn't an option because …
A Measurements may be too expensive
B Production volume may be too low
C Products may have a long cycle time
D All of the above
5. The main use of I-MR chart is
A Monitoring the stability of a process
B Determining whether a process is stable and ready to be improved.
C Demonstrating improved process performance.
D All of the above
6. The distribution that follows principles of an exponential distribution is:
A Poisson
B Binomial
C Chi-Square
D Normal
1
 2

7. …….. chart can alert you to changes that reveal a problem you should address.
A I-MR
B X-Bar and R-Charts
C X-bar and S chart
D NP Control Chart
8. …chart can confirm (or deny) the stability of your process before you implement a change. 
A I-MR
B X-Bar and R-Charts
C X-bar and S chart
D NP Control Chart
9. Which of the following distributions describes the ratios of two variances drawn from the same
normal population?
A F statistic
B Student's t-test
C Chi-square
D Normal
10. …… charts can provide that proof of process improvement.
A I-MR
B X-Bar and R-Charts
C X-bar and S chart
D NP Control Chart
11. …… used to monitor processes for Large Sample Size
A I-MR
B X-Bar and R-Charts
C X-bar and S chart
D NP Control Chart
12. Which of these are not Multivariate analysis?
A Factor analysis
B MANOVA
C ANOVA
D Cluster analysis

2
 3

13. …… used with data collected in subgroups that are the same size
A I-MR
B X-Bar and R-Charts
C X-bar and S chart
D C Control Chart
14. The distribution that follows principles of Coin Flip Distribution is:
A Poisson
B Binomial
C Bernoulli
D Normal
15. Which is true about critical path?
A Zero slack
B Event oriented
C Shortest path
D Time and cost not considered
16. ANOVA analysis is the analysis of variation in ….
A mean
B median
C mode
D All of the above
17. Some activities cannot start until others are finished. Inevitably, that presents the risk of..
A Effectiveness
B bottleneck
C Efficiency
D All of the above
18. Which of the following statistical tests should be used by the Green Belt for testing the means
between two inter-related groups?
A 2 Sample t assuming equal variances
B 2 Sample t assuming unequal variances
C Paired t-test
D z test

3
 4

19. …… is a project planning method that focuses on identifying tasks that are depended on other
tasks for their timely completion.
A Improvement Process
B Incremental Improvement.
C Critical Path analysis (CPA)
D All of the above
20. …… used to set a realistic deadline for a project and to track its progress along the way
A Improvement Process
B Incremental Improvement.
C Critical Path analysis (CPA)
D All of the above

‫بالتوفيق‬