Scribd
Upload
370 views2 pages

H-100 Control Panel

Uploaded by

Pablo Caña
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
370 views2 pages

H-100 Control Panel

Uploaded by

Pablo Caña
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

H-100 CONTROL PANEL

The Quiet-Test™ H-100 Control Panel is a digital


microprocessor electronic controller that integrates all engine
and transfer switch functions into a single control system.

• Digital Controls for All Saftey Shutdowns


• Isochronous Governor Control
• Digital 3 Phase Sensing Voltage Regulator
• Sealed Digital Circuit Board
• Mates with HTS Transfer Switch and Any 2-wire Start ATS
• Alarm and Event Logging
• Built-in Diagnostics
• Internal PLC

Features
• Two 4-line x 20 Displays • Shutdowns
• Full System Status - Overvoltage
• 3 Phase Sensing Digital Voltage Regulator - Overspeed
• Remote Ports - Low Oil Pressure
- RS-232 - High Coolant Temperature
- RS-485 - Low Coolant Level
- CANbus • Emergency Stop
• Waterproof Connections • On/Off/Manual Switch
• Built -in PLC • Not in Auto Flashing Light
• Full Range Standby Operation • Audible Alarm for Fault Condition
• Full System Status • Transfer Switch Logic Communicates with HTS
- 3 Phase AC Volts Transfer Switch
- 3 Phase Amps • Selectable Low Speed Exercise
- kW • Temperature Range: -40° to +70°C
- Power Factor
- Reactive Power Codes and Standards
- Oil Pressure • UL 508
- Water Temperature • Configurable to NFPA 110, Level 1 or 2
- Water Level
- Oil Temperature (Optional) The generator set parameters can be manipulated and
- Fuel Pressure monitored without standing in front of the control panel with
- Engine Speed GenLink® software. The Generac H-100 control panel also
- Battery Voltage wmonitors and controls transfer switch functions when used
- Alternator Frequency with the HTS transfer switch.
- Time • Monitors Utility Voltage
- Date • Monitors Generator Voltage
- Transfer Switch Status • Timer for Line Interrupt Delay
GENERATOR CONTROLS

- Run Hours • Timer for Engine Warmup


- Service Reminders • Timer for Minimum Engine Run Time
- Trending • Timer for Return to Utility Position
- Fault History (Alarm Log) • Timer for Engine Cooldown
- I2T Function for Full Generator Protection • Built-in Exerciser Timer (7 Day)
• Remote Communications • Additional 2-wire Start Controls for Any 2-wire
• Programmable Auto Crank Transfer Switch

1 OF 2
Part No. 0172110SBY
Rev. F 02/08/23
H-100 CONTROL PANEL

Typical Control Connection

RS485 -
HTS
Quiet-Test™ H-100 2-wire
Transfer
Controller with Ground
Switch
on Generator Connection
for Control

Any 2-wire
or Start ATS

GENERATOR CONTROLS

2 OF 2

Generac Power Systems, Inc. | P.O. Box 8 | Waukesha, WI 53187 Part No. 0172110SBY
P: (262) 544-4811 © 2023 Generac Power Systems, Inc. All rights reserved. All specifications are subject to change without notice. Rev. F 02/08/23

You might also like