EGPWS Upload
EGPWS Upload
** ON A/C ALL
TASK 34-48-00-610-001-A
Uploading of the Enhanced GPWC Database
C. Referenced Information
REFERENCE DESIGNATION
(Ref. 24-41-00-861-002-A). Energize the Aircraft Electrical Circuits from the External Power
(Ref. 24-41-00-861-002-A-01). Energize the Aircraft Electrical Circuits from the APU
(Ref. 24-41-00-861-002-A-02). Energize the Aircraft Electrical Circuits from Engine 1(2)
(Ref. 24-41-00-862-002-A). De-energize the Aircraft Electrical Circuits Supplied from the External
Power
(Ref. 24-41-00-862-002-A-01). De-energize the Aircraft Electrical Circuits Supplied from the APU
(Ref. 24-41-00-862-002-A-02). De-energize the Aircraft Electrical Circuits Supplied from the Engine
1(2)
(Ref. 31-32-00-860-001-A). Procedure to Get Access to the SYSTEM REPORT/TEST Menu Page
(Ref. 34-48-00-740-002-B). BITE Test of the Enhanced GPWS
(Ref. 52-41-00-410-002-A). Close the Avionics Compartment Doors after Access
Enhanced GPWC Face SHEET 1
Sub-Menu Function - LRU IDENT SHEET 1
STATUS
INDICATORS
(LED)
PCMCIA
CARD SLOT
UPLOAD/DOWNLOAD
STATUS INDICATORS
(LED)
P1
INSTRUCTION LABEL
N_MM_344800_3_AAM0_01_00
1L L AS T L EG R E P OR T 1R 1L F MGC 1R
2L L AS T L EG E C AM R E P OR T 2R 2L DAT A L I NK 2R
3L P R E V I OU S L EGS R E P OR T 3R 3L A I DS 3R
4L A V I ON I C S STATUS 4R 4L CFDS 4R
5L S Y S T EM R E P OR T / T E S T 5R 5L RE TURN 5R
6L POS T F L I GH T REP PR I NT 6R 6L 6R
S E L ECT DES I RED S Y S T EM
2L AFS FUE L 2R 2L I R 1 RA 1 2R
4L E L EC I NS T 4R 4L I R 2 DM E 1 4R
5L F I RE P RO T L /G 5R 5L ADR 3 DM E 2 5R
NEXT
PAGE
NEXT
PAGE
2L V OR 1 AD F 2 2R 2L G PWC 2R
3L V OR 2 ATC 1 3R 3L GP S 1 3R
4L R AD AR 1 ATC 2 4R 4L GP S 2 4R
5L R AD AR 2 ML S 1 5R 5L TCAS 5R
6L RE TURN ML S 2 6R 6L RE TURN 6R
GPWC GP WC
L RU I D E N T I F I C A T I ON L AST LEG CL ASS 3
1L 1R 1L REPORT FAULTS 1R
P R E V I OU S L E GS
2L P ART N U MB E R : 2R 2L REPORT TES T 2R
XXX - X XX - X X X
3L MOD : XX 3R 3L L RU I DE NT 3R
S E R I A L N U MB E R : XXXXXXX
4L T E RRA I N DB / N : XXX 4R 4L GND SCANNI NG 4R
ENV MOD DB / N : XXX T R OU B L E S H OOT GR OU ND
5L 5R 5L DAT A REPORT 5R
N_MM_344800_3_AAN0_01_00
3. Job Set-up
** ON A/C ALL
** ON A/C ALL
Subtask 34-48-00-865-066-A
D. Make sure that this(these) circuit breaker(s) is(are) closed:
** ON A/C ALL
NOTE: Before you load the software make sure that the version of the terrain data base is correct.
(1) Make sure that the COMPUTER OK LED on the face of the Enhanced GPWC, is on.
(2) Open the door on the face of the Enhanced GPWC.
(3) Put the PCMCIA card into the PCMCIA card slot.
(4) During software loading, the IN PROG LED stays on and the COMPUTER OK LED is off.
(5) When the loading is completed, the XFER COMP LED comes on.
(6) Remove the PCMCIA card from the Enhanced GPWC.
(7) After approximately 15 seconds, the COMPUTER OK LED comes on to tell the operator that the
loading of the PCMCIA card contents is completed.
(8) On the label on the front panel door of the Enhanced GPWC, write the number of the database that
you loaded.
(9) Close the door on the face of the Enhanced GPWC.
Subtask 34-48-00-710-079-A
B. Do a check of the P/Ns TERRAIN DB software and ENV MOD software uploaded in the Enhanced
GPWC.
(1) On the MCDU, get the SYSTEM REPORT/TEST NAV: RADIO NAV page 3/3 (Ref. AMM TASK 31-
32-00-860-001) then the LRU IDENTIFICATION page
(Ref. Fig. Sub-Menu Function - LRU IDENT SHEET 1)
(2) On the LRU IDENTIFICATION page, make sure that the P/Ns TERRAIN DB software and ENV MOD
software uploaded in the Enhanced GPWC are the same as the P/Ns written on the label of the
PCMCIA card.
Subtask 34-48-00-740-053-A
C. Do the BITE Test of the Enhanced GPWC (Ref. AMM TASK 34-48-00-740-002) .
** ON A/C ALL
5. Close-up
** ON A/C ALL
End of document