Scribd
Upload
133 views1 page

4611V015 - 01gb Big End Bearing Bore

This document provides specifications for measuring the big end bearing bore of connecting rods for a W46F engine. It specifies that connecting rod screws must be tightened to 2250 bar for M52 screws and 1600 bar for M45 screws before measuring. The maximum allowed difference between the maximum and minimum diameters is 0.14 mm. Measurement deviations are to be reported in hundredths of a millimeter. Engine details like number, reference type, and ambient temperature are to be provided. Measurement date, place, and person performing the measurement are also to be recorded.

Uploaded by

Bertan Chirim
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
133 views1 page

4611V015 - 01gb Big End Bearing Bore

This document provides specifications for measuring the big end bearing bore of connecting rods for a W46F engine. It specifies that connecting rod screws must be tightened to 2250 bar for M52 screws and 1600 bar for M45 screws before measuring. The maximum allowed difference between the maximum and minimum diameters is 0.14 mm. Measurement deviations are to be reported in hundredths of a millimeter. Engine details like number, reference type, and ambient temperature are to be provided. Measurement date, place, and person performing the measurement are also to be recorded.

Uploaded by

Bertan Chirim
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Services, Wärtsilä Finland Oy

Section Valid for Ref. Date Issue Document No. Page


11 Connecting rod W46F WFI-S 28-May-2012 01 4611V015 1(1)

Installation name: Engine No: Engine ref. type: W46F

Engine type: Application: Ambient temp: °C Fuel type: Engine rhrs:

Big end bearing bore


Connecting rod screws must be tightened before measuring.
Hydraulic pressure when tightening: - M52 screws 2250 bar
- M45 screws 1600 bar
Tightening order: M52 first. (See engine manual.)

Nominal diameter without shells: mm

Maximum allowed difference between Dmax and Dmin: 0.14 mm

Reference diameter (mm): 439 mm

Measurement tool(s) id: Measurement tools(s) S/N:

Deviations to be given in 1/100 mm


Bank: Cylinder number
1 2 3 4 5 6 7 8 9 10
L
D1
R
L
D2
R
L
D3
R
L
D4
R
L
D5
R
Max. dev:
Running hours:
ID No:
Temp. (°C):
Remarks:

Date of measurement: Place: Name:

Wärtsilä Finland Oy P.O. Box 252 (Tarhaajantie 2) Telecop. +358 10 709 1847 Tel. +358 10 709 0000 Business ID 0773744-3
Services, Vaasa FIN-65101 Vaasa, Finland Telecop. +358 10 709 1380 Registered Office: Vaasa

Wärtsilä Finland Oy P.O. Box 50 (Stålarminkatu 45) Telecop. +358 10 709 3279 Tel. +358 10 709 0000
Services, Turku FIN-20811 Turku, Finland Telecop. +358 10 709 3410

You might also like