Scribd
Upload
483 views

Form PAUT

This phased array ultrasonic testing report documents the inspection of welds on an item or component, listing the inspection parameters, equipment used, and locations and measurements of any discontinuities found, with recommendations on acceptance or rejection. Probe types and frequencies, scanning positions, and details of any defects like cracks or porosity are included. Signatures are provided to verify the inspection and evaluation were completed according to the given standards and procedures.

Uploaded by

Luong Ho Vu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
483 views

Form PAUT

This phased array ultrasonic testing report documents the inspection of welds on an item or component, listing the inspection parameters, equipment used, and locations and measurements of any discontinuities found, with recommendations on acceptance or rejection. Probe types and frequencies, scanning positions, and details of any defects like cracks or porosity are included. Signatures are provided to verify the inspection and evaluation were completed according to the given standards and procedures.

Uploaded by

Luong Ho Vu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

PHASED ARRAY ULTRASONIC TESTING

REPORT
Project Name: Report No.:
Item / Category.:
Client Name: Request No.:
Procedure No: Weld Preparation:
Acceptance Standard: Calibration, Reference Block:
PAUT instrument type: Material: DWG No.:
PAUT instrument: Surface Condition:
Scanner type: Couplant: WPS No.: Page
Matl.: SPP Date of inspection:
Probe Wedge
PCD/
Skew Range Sensitivit
Type Serial No Freq (MHz) PCS Type Serial No Angle
(mm)/µs y (dB)
(mm)
PA-1(SK90)
PA-1(SK270)
location
Length of defect

reference level
dB higher than

Identification No.:
(mm)
(mm)

Discontinuity Type of weld


No. Welder Remark
Thickness

Scanning

Start Xs
Position

Evaluation defect
End Xe
Length

length
Scan
(mm)

(mm)
(mm)

Joint
No.

ABBREVIATION: ACC: Accepted U: Under Cut PCS: Probes center seperation LF: Lack of Fusion P: Porosity
(note: all dimensions in REJ: Rejected O/D: Outside diameter LxT: Length x thickness CR:Crater Crack SI: Slag inclusion
millimeter)
R/S: Re-scan C: Crack CP:Cluster Porosity LOP : Lack Of Penetrate
CANDT
Name: Name: Name: Name:
Signature: Signature: Signature: Signature:

Date: Date: Date: Date:

You might also like