Scribd
Upload
2K views2 pages

Fault Code P1830 (Controlled Manual Gearbox ECU)

This document provides information about fault code P1830 related to a controlled manual gearbox ECU. The fault code indicates a vehicle speed coherence fault where the wheel speed signal is reading 0 rpm. This fault code will appear if the vehicle speed is higher than 3 km/h while the engine is running and a gear is engaged with the clutch closed. It can also occur if the input shaft speed is over 6000 rpm with the clutch open. The fault must not reoccur for 2 seconds to clear. This fault activates warning lights and limits the vehicle to manual mode with gears only up to third gear possible.

Uploaded by

thierry.fifieldoutlook.com
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
2K views2 pages

Fault Code P1830 (Controlled Manual Gearbox ECU)

This document provides information about fault code P1830 related to a controlled manual gearbox ECU. The fault code indicates a vehicle speed coherence fault where the wheel speed signal is reading 0 rpm. This fault code will appear if the vehicle speed is higher than 3 km/h while the engine is running and a gear is engaged with the clutch closed. It can also occur if the input shaft speed is over 6000 rpm with the clutch open. The fault must not reoccur for 2 seconds to clear. This fault activates warning lights and limits the vehicle to manual mode with gears only up to third gear possible.

Uploaded by

thierry.fifieldoutlook.com
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Information : Fault code P1830 (Controlled manual gearbox ECU)

D6AX04X2
Information : Fault code P1830 (Controlled manual gearbox ECU)
P0

Controlled manual gearbox ECU


Fault code P1830
After sales description of the fault code Vehicle speed coherence fault : No signal
The wheel speed signal is on 0 rpm
Description of the diagnostics
The time of appearance of the fault code is 2s
Possibility 1
The following conditions have to be met
- Ignition on
- The starter motor is not operating
- engine running
- Gear engaged
- Clutch closed
- Vehicle speed higher than 3 km/h
Context of appearance of the fault code Possibility 2
The following conditions have to be met
- Ignition on
- The starter motor is not operating
- engine running
- Gear engaged
- Clutch open
- Speed of rotation of the input shaft greater than the
idling speed plus 6000 rpm
Technical precision on the context of Supply voltage correct between 8V and 16V (Pin 3 of
the 28-way connector)
appearance of the fault code Absence of fault codes P1749 - U0415 - U1000 -
U1003 - U1113
Conditions of disappearance of the fault No faults for 2 seconds
The gears above 3rd gear cannot be engaged
Down-grade modes if fault present
Activation of Manual mode
"SERVICE" warning lamp
Sport warning lamp
Switching on of the warning lamp and/or Snow warning lamp
warning message
Automatic or 6-speed piloted manual gearbox
warning lamps (Orange PRND triangle)
Display of a "-" on the fascia panel
Difficult/impossible to change a gear
Main customer complaints likely
Lack of power
Piloted manual gearbox ECU
Suspect areas
Sealing of the connectors and harnesses

You might also like