Scribd
Upload
174 views

Question Bank For MP-III - B.Tech II

The document contains 12 questions about CNC machines and programming. It asks to [1] differentiate NC and CNC machines, [2] describe basic CNC machine components with a sketch, and [3] discuss CNC machine design structure with a sketch. It also asks about [4] machine tool design considerations, [5] differentiating motor types, [6] illustrating feedback devices, [7] introducing part programming elements, [8] writing a program to drill holes, [9] writing a program for the given diagram, [10] writing a turning program, [11] listing G and M codes, and [12] differentiating programming methods.

Uploaded by

ABHISHEK
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
174 views

Question Bank For MP-III - B.Tech II

The document contains 12 questions about CNC machines and programming. It asks to [1] differentiate NC and CNC machines, [2] describe basic CNC machine components with a sketch, and [3] discuss CNC machine design structure with a sketch. It also asks about [4] machine tool design considerations, [5] differentiating motor types, [6] illustrating feedback devices, [7] introducing part programming elements, [8] writing a program to drill holes, [9] writing a program for the given diagram, [10] writing a turning program, [11] listing G and M codes, and [12] differentiating programming methods.

Uploaded by

ABHISHEK
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Question Bank for MP-III

1. Differentiate between NC and CNC machines


2. Enlist and describe the basic components of CNC machine with neat sketch.
3. Discuss with neat sketch a design structure of CNC machine.
4. Describe the basic design consideration of a machine tool.
5. Differentiate between AC motor, DC motor and steeper motor.
6. Illustrate following feedback devices:-
a. Encoders
b. Tachometer
c. Servo motors
d. Linear motors

7. Introduction of part programming and its elements.

8. Write an efficient CNC part program to drill 35 holes of diameter of 0.5 inch each in a machine
Component as shown in Fig. (The raw material to be employed is mild steel plate of 0.4 inch
thickness.)

9. Write a part programming for the given diagram below:-[Cutter diameter is D20 mm]
[Note:- All dimensions are in mm]

10. Write a part program for turning operations being carried out on a CNC Turning center.(Final profile
to be generated on a bar stock using CNC Turning m/c)

11. Enlist 10 G-codes and 10 M-codes with its description.

12. Differentiate between method of programming: - Manual and Computer Assisted Part
Programming.

You might also like