We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 2
DTC P0089 FUEL PUMP
< SERVICE INFORMATION > [YD25DDTi]
DTC P0089 FUEL PUMP
On Board Diagnosis Logic
NOTE:
If DTC P0089 is displayed with DTC P0652 or P0653, first perform trouble diagnosis for DTC P0652 or
P0653. Refer to EC-214.
DTGNe, | Trouble dagnosie name DIG detecting condition Possible cause
> Fuel pump
008s: too much higher than the target vawe. |” Air ixed with fuel
eee Fuel pump performance | Fuel pressure s too much higher than the target vate. | 7 (To
+ Fuol al pressure sensor
DTC Confirmation Procedure nraoccemaousnss
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at
least 10 seconds before conducting the next test
1, Start engine and warm it up to normal operating temperature.
2. Let engine idle for at least 30 seconds.
3. Check 1st trip DTC.
4, If Ast trip DTC is detected, go to EC-89, “Diagnosis Procedure”
Diagnosis Procedure soos
1 .PERFORM FUEL PUMP LEARNING VALUE CLEARING
NOTE:
If the DTC is detected because of air mixed with fuel (e.: caused by lack of fuel), it may become normal by
performing following procedure,
With CONSULT-III
Tum ignition switch ON.
Perform Fuel Pump Learning Value Clearing, Refer to EC-23, "Fuel Pump Learning Value Clearing’
Start engine and let it idle for at least 60 seconds.
Select "SELF-DIAG RESULT" mode with CONSULT: IL
Touch “ERASE
Perform EC-89, "DTC Confirmation Procedure”, again
Is ‘st trip DTC detected again?
5 With GST
‘Tum ignition switeh ON.
Perform Fuel Pump Learning Value Clearing, Refer to EC-23, "Fuel Pump Learning Value Clearing’
Start engine and let it idle for at least 60 seconds.
Select Service $04 with GST.
Perform EC-89, "DTC Confirmation Procedure”, again,
Is tst trip DTC detected again?
(as or No.
Yes >>GOTO2
No >> INSPECTION END
2.CHECK FUEL RAIL PRESSURE SENSOR
if PUR ONAGNOMAONS
Refer to EC-131, “Component Inspection”,
OK or NG
OK >> GOTO3.
NG >> Replace fuel rail
3. CHECK FUEL PUMP
Perform EO-205, "DTO Confirmation Prosedure™
Ec-89 DTC P0089 FUEL PUMP
< SERVICE INFORMATION > [YD25DDTi]
QK or NG
OK >> GOTOS.
NG >>GOTO4.
4. REPLACE FUEL PUMP
1. Replace Fuel pump
2. Perform Fuel Pump Learning Value Clearing, Refer to EC-23, "Fuel Pump Learning Value Clearing",
>> INSPECTION END
5.CHECK INTERMITTENT INCIDENT
Refer to EC-70.
>> INSPECTION END
Removal and Installation imrowscnvsee
FUEL PUMP
Refer to EO-24,
EC-90
