Scribd
Upload
578 views8 pages

B. Router B C. Router C D. Router A

This document contains questions and multiple choice answers about networking technologies like routing, wireless LAN controllers, NAT, and Cisco DNA Center. Question 258 asks about configuring NAT and a static route to allow a PC to ping a router's loopback interface. The correct answer is B, which shows the necessary NAT and routing configuration on routers R1 and R2.

Uploaded by

Adi Trimukti
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
578 views8 pages

B. Router B C. Router C D. Router A

This document contains questions and multiple choice answers about networking technologies like routing, wireless LAN controllers, NAT, and Cisco DNA Center. Question 258 asks about configuring NAT and a static route to allow a PC to ping a router's loopback interface. The correct answer is B, which shows the necessary NAT and routing configuration on routers R1 and R2.

Uploaded by

Adi Trimukti
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 8

251.

Refer to the exhibit. PA is communicating with another device at IP address 10.227.226 255. Through which
router does router Y route the traffic?

A. Router D
B. Router B
C. Router C
D. Router A

Answer: A

252. SIP-based Call Admission Control must be configured in the Cisco WLC GUL. SIP call-snooping ports are
configured. Which two actions must be completed next? (Choose two.)

A. Configure two different QoS roles for data and voice traffic,
B. Set the GOS levelito platinum for voice traffic
C. Enable traffic shaping for the LAN interface of the WLC.
D. Enable Media Session Snooping on the WLAN.
E. Set the QoS level to silver or greater for voice traffic.

Answer: BD
253. Which cable type must be used to interconnect one switch using 1000 BASE-SX GBIC modules and another
switch using 1000 BASE-SX SFP modules?

A. SC to SC
B. LC to SC
C. LC to LC
D. SC to ST

Answer: B

254.

Refer to the exhibit. User traffic originating within site B is falling to reach an application hosted on IP address
192.168.0.10, which is located within site A. What is determined by the routing table?

A. The default gateway for site B is configured incorrectly


B. The lack of a default route prevents delivery of the traffic
C. The traffic:is blocked by an implicit deny in an ACL on router?,
D. Thebtraffic to 192.168.0.10 requires @)static route to be configured in router

Answer: B
255. Which two server types support domain name to IP address resolution? (Choose two.)

A. ESX host
B. filetransfer
C. Resolver
D. Web
E. authoritative

Answer: CE

256.

Refer to the exhibit. What is the subnet mask for route 172.16.4.0?

A. 295.255.255.192
B. 255.255.2400
C. 255.255 .254.0
A. D..255,255.248.0

Answer: D

257. When an access point is seeking to join a wireless LAN controller, which message is sent to the AP-Manager
interface?

A. DHCP discover
B. Discovery request
C. Discovery response
D. DHCP request

Answer: B
258.

Refer to the exhibit.An engineer must translate the PC1 IP address to 10.199.77.100 and permit PC1 to ping the
loopback 0 interface on router R2. What command set must be used?

A. RI#

interface LoopbackO

ip address 10.1.1.1 255.255.255.255

interface Fast&themet0/0

ip address 10.139.91.1 255.255.255:252

ip nat inside

ip virtual-reassembly in

interface Fast€themet1/0

ip address 172.16.29.1 255.255.255.0

ip nat outside

ip virtual-reassembly in

router eigrp 100

network 10.1.1.1 0.0.0.0

network 10.139.91.0 0.0.0.3

!
ip nat inside source static 10.199.77.100 172.16.29.78

R2#

ip route 10.199.77.100 255.255.255.255 10.139.91.1

B. R1#

interface LoopbackO

ip address 0.1.1.1 255.255.255.255

ites FasiEtiemet0/0

ip address 10.139.91.1 255.255.255.252

ip nat outside

ip virtual-reassembly in

interface FastEthernet1/0

ip address 172.16.29.1 255.255.255.0

ip nat inside

ip virtual-reassembly in

router eigrp 100

network 10.1.1.1 0.0.0.0

network 10.139.91.0 0.0.0.3

ip nat inside source static 172 16.29.78 10.99.77.100

R2#

ip route 10.199.77.100 255.255.255.255 10.139.91.1


C. R1#

interface LdopbackO

ip address 10.1.1.1 255.255.255.255

interface FastEthemet0/0

ip address 10.139.91.1 255.255.255.252

ip nat outside

ip virtual-reassembly in

interface FastEthermett/0

ip address 172.16.29.1 255.255.255.0

ip nat inside

ip Virtual-reassembly in

router eigrp 100

network 10.1.1.1 0.0.0.0

network 10.139.91.0 0.0.0.3

ip nat inside source static 172.16.29.78 10.199.77.100

R2#

ip route 172.16.29 78 255.255.256.265 10.139.91.1


D. R1#

interface Lodpback0

ip address 10.1.1.1 255.256.255.255

interface FastEthemet0/0

ip address 10.139.91.1 265.255.255.252

ip nat inside

ip virtual-reassembly in

infertace FastEthemet /0

ip address 172.16.29.1 255 255.255.0.

ip nat outside

ip virtual-reassembly in

router eigrp 100.

network 10.1.1.1 0.0.0.0

network 10.139.91.0 0.0.0.3

ip nat inside source static 172.16.29.78 10.199.77.100

R2#

ip route 172:16 29.78 255.255.255.255 10.199.91.1

Answer : B
259. Which channel-group mode must be configured when muttple distribution switch interfaces connected to a
WLC are bundled?

A. channel-group mode active

B. channel-group mode desirable

C. channel-group mode passive

D. channel-group mode on

Answer: D

260. What is the functionality of the Cisco DNA Center?

A. data center network policy controller

B. software‘defined controller for automation f devices and services

C. IP address poo! distribution scheduler

D. console server that permits secure access to all network devices

Answer: B

You might also like