Scribd
Upload
14 views

Assignment SoM

This document contains 5 questions regarding strength of materials calculations for beams. The questions involve determining deflections and slopes of beams using different methods like Macauley's method, double integration method, and moment area method. Beams with different support conditions like overhanging, simply supported and cantilever are considered. Parameters like modulus of elasticity, moment of inertia, load, and span are provided to calculate requested values.

Uploaded by

Beast Hunter
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
14 views

Assignment SoM

This document contains 5 questions regarding strength of materials calculations for beams. The questions involve determining deflections and slopes of beams using different methods like Macauley's method, double integration method, and moment area method. Beams with different support conditions like overhanging, simply supported and cantilever are considered. Parameters like modulus of elasticity, moment of inertia, load, and span are provided to calculate requested values.

Uploaded by

Beast Hunter
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Assignment: Strength of Materials

Last date of Submission: 8th November 2022

Q.1 An overhanging beam ABC is loaded as shown in the figure below. Determine the
deflection of the beam at point C in terms of E, I, W, and L. Use Macauley’s method
only.

Q.2 Use the double integration method and determine the deflection of the beam
under the load. Take beam as a simply supported of 3 m span subjected to a point
load of 40 kN at s distance of 1 m from the left end. Take EI for the beam as 12 × 109
N/mm2.

Q.3 A beam simply supported at its both ends carries a uniformly distributed load of
16 kN/m. If the deflection of the beam at its center is limited to 2.5 mm, find the span
of the beam. Take EI =9 × 109 N/mm2.

Q.4 A beam is shown in the figure below. Calculate the slope of the beam at C, A
and B. Take EI = 40 × 103 kN-m2.

Q5. For a cantilever beam as shown in the figure below. Determine the slope and
deflection at end D by using the moment area method. Take a =1m , M0 = 30 kNm,
E = 200 GPa and I = 3.6 × 10-5 m4.

You might also like