floor eposil Formerly "Eposil" FLOORING
Solvent based epoxy sealing primers
PRODUCT
floor eposil is a two-component epoxy primer designed
to seal the porosity of the substrate thus providing a
homogeneous and adherent surface to various epoxy
coating systems. It improves the resistance of concrete to
chemicals and daily abrasion, and reduces its absorption of
water and salts.
SCOPE OF USE
• Parking decks
• Bridge decks
• Industrial floors
• Food industry floors
CHARACTERISTICS
Colors Transparent
Solid content 60% by volume PACKAGING
Density 1.05 (Clear) Leb Syria Jordan UAE Qatar Kuwait KSA Oman
Pot life 2-3 hours at 20°C 20 lit 20 lit 20 lit 20 lit 20 lit 20 lit 20 lit 20 lit
Drying time 1 to 2 hours at 30°C
Flash point >26°C
Thickness of dry film 55 microns
Thickness of wet film 190 microns
Over coating application after 8 hours PRODUCT APPLICATION
Max over coating delay 4 days floor eposil is applied using a roller, brush or an airless
sprayer
For very porous surfaces two coats may be required to seal
INSTRUCTIONS FOR USE effectively.
SURFACE PREPARATION
Careful surface preparation is essential for optimum finishing
and durability. CONSUMPTION
Maximum moisture content should not exceed 5%. 0.09 litre/m²
New concrete structures need to dry for at least 28 days. Old The concrete surface greatly affects coverage rate.
coatings, dirt, fats, oils or organic substances need to be
removed by a grinding machine. Possible surface irregularities STORAGE
need to be smoothened. Any loose surface pieces need to be One year after manufacturing date in its original packing non
thoroughly removed. The surface should then be roughened open and in dry cool area.
using a dust-free “grit-blasting” machine.
The substrate should be clean, dry and sound, free of any SAFETY PRECAUTIONS
dust or contamination which may harmfully affect the Application should be done in a ventilated area away from
adhesion of the primer layer. any heat source. Wear protective gear for hands and eyes
WARNING: Do not wash surface with water! and avoid breathing of vapor. If mixed resin comes into
contact with the skin, it should be promptly removed before
PRODUCT PREPARATION hardening, followed by thoroughly washing the skin with
Mix the two parts for 2-3 minutes by an electric mixer with soap and water. In case of heavy vapor inhalation, place
low rotation speed (< 300 rpm). affected person in an open-air area. In case of contact with
The epoxy must be well mixed to ensure proper chemical eyes, wash thoroughly with clean water. If swallowed, do not
reaction. induce vomiting. In all cases, seek medical attention. In case
After mixing, apply immediately. of fire, use CO2 foam to extinguish. Tightly seal containers
when not in use, store them away from heat and carefully
dispose empty ones.
1/2 Technical data sheet . Edition: 08.14-A www.sodamco-weber.com
floor eposil FLOORING
DISCLAIMER
While the company guarantees its products against defective
materials, the use and application of these products are
made without guarantee since the conditions of their application
are beyond its control. It is recommended to verify with the
company that the product is suitable for the intended use,
and that this Data Sheet version is the latest one. The company
may modify it without prior notice. Technical characteristics
are listed for guidance only. For more information, please
contact the company’s office in your location.
NOTE
The information included on this Technical Data Sheet is the
sole property of SODAMCO Holding. The unauthorized disclosure,
use, dissemination or copying (either whole or partial) of this
data sheet or any information it contains, is prohibited and
subject to legal pursuit.
PG:22
2/2 Technical data sheet . Edition: 08.14-A www.sodamco-weber.com
