GENERAL NOTES: LEGEND & SYMBOLS: SCHEDULE OF LOADS: PP1

1. ALL ELECTRICAL INSTALLATION WORKS HEREIN SHALL BE DONE IN ACCORDANCE WITH the
THESE PLANS AND SPECIFICATIONS, THE APPLICABLE PROVISIONS OF THE LATEST
EDITION OF THE P.E.C. THE RULES AND REGULATIONS OF THE LOCAL ENFORCING
SERVICE ENTRANCE TWO WAY SWITCH
SITE CKT. NO. LOAD SERVED VA VOLTS AMP
OUTLET
L.O. C.O.
BRANCH CIRCUIT
PROTECTION
SIZE OF WIRES SIZE OF CONDUIT

AUTHORITY AND THE REQUIREMENTS OF THE LOCAL POWER COMPANIES,THE CIRCUIT BREAKER 1 LIGHTING OUTLET (1ST. FLR.) 800 230 3.48 16 15 AT, 2P CB USE: 2-2.2 sq. mm. THHN STR. WIRE 20 mm Ø PVC Conduit
ELECTRICAL WORKS SHALL BE UNDER THE IMMEDIATE SUPERVISION OF A DULY TWO GANG SWITCH
LICENSED REGISTERED ELECTRICAL ENGINEER. 2 LIGHTING OUTLET (2ND. FLR.) 1,200 230 5.22 24 15 AT, 2P CB USE: 2-2.2 sq. mm. THHN STR. WIRE 20 mm Ø PVC Conduit
CIRCUIT HOMERUN THREE GANG SWITCH
2. THE ELECTRICAL SERVICE VOLTAGE SHALL BE 1-PHASE, 3-WIRE, 230 VOLTS, 60 HZ. 3 CONV.OUTLET (1ST. FLR.) 1,800 230 7.83 10 20 AT, 2P CB USE: 2-3.5 sq. mm. THHN STR. WIRE 20 mm Ø PVC Conduit

3. THE ELECTRICAL WIRING INSTALLATION SHALL BE DONE IN PVC CONDUIT. FLEXIBLE GROUND LINE 4 CONV.OUTLET (2ND. FLR.) 1,800 230 7.83 10 20 AT, 2P CB USE: 2-3.5 sq. mm. THHN STR. WIRE 20 mm Ø PVC Conduit
CONDUIT SHALL BE USED WHERE REQUIRED MINIMUM SIZE FOR ALL CONDUITS SHALL BE CABLE TV OUTLET
15 mm DIA. ELECTRICAL TRADE SIZE, CONDUITS SHALL BE RIGID STEEL CONDUITS ( RSC) 5 CONV.OUTLET (2ND. FLR.) 1,800 230 7.83 10 20 AT, 2P CB USE: 2-3.5 sq. mm. THHN STR. WIRE 20 mm Ø PVC Conduit
AND SHALL BE USED IN MAIN SERVICE ENTRANCE. PP POWER PANEL BOARD 2.0 HP ACU OUTLET - MASTER'S
6 2,250 230 9.78 1 30 AT, 2P CB USE: 2-3.5 sq. mm. THHN STR. WIRE 20 mm Ø PVC Conduit
TELEPHONE WALL OUTLET BEDROOM (2ND. FLR.)
4. ALL WIRES SHALL BE COPPER AND THERMOPLASTIC INSULATED TYPE "THHN" OR "THW" 7 1.5 HP ACU OUTLET - BED ROOM 1
1,750 230 7.61 1 30 AT, 2P CB USE: 2-3.5 sq. mm. THHN STR. WIRE 20 mm Ø PVC Conduit
UNLESS OTHERWISE INDICATED, THE MINIMUM SIZE FOR POWER AND LIGHTING SHALL BE LIGHTING CIRCUIT LINE (2ND FLR.)
2.0 SQ.MM THE CONTROL WIRES SHALL BE AS INDICATED OR SPECIFIED ELSEWHERE ON 8 1.5 HP ACU OUTLET - BED ROOM 2
CONVENIENCE OUTLET 1,750 230 7.61 1 30 AT, 2P CB USE: 2-3.5 sq. mm. THHN STR. WIRE 20 mm Ø PVC Conduit
PLANS. (2ND FLR.)
9 ELEC. WATER HEATER OUTLET
POWER CIRCUIT LINE 1,000 230 4.35 1 20 AT, 2P CB USE: 2-3.5 sq. mm. THHN STR. WIRE 20 mm Ø PVC Conduit
5. THE CONTRACTOR SHALL VERIFY AND ORIENT THE ACTUAL LOCATION OF SERVICE ENTRANCE (MASTER'S T&B @ 2ND. FLR.)
COUNTER TOP ELEC. WATER HEATER OUTLET
FOR CONNECTION TO THE POWER SUPPLY. 10 1,000 230 4.35 1 20 AT, 2P CB USE: 2-3.5 sq. mm. THHN STR. WIRE 20 mm Ø PVC Conduit
CONVENIENCE OUTLET ( T&B @ 1ST. FLR.)

6. ALL SERVICE ENTRANCE EQUIPMENT, SWITCHES, PANELBOARDS, LIGHTING FIXTURES AND KILOWATT-HOUR METER 11 RANGE OUTLET (D. KITCHEN) 3,000 230 13.04 1 40 AT, 2P CB USE: 2-8.0 sq. mm. THHN STR. WIRE 20 mm Ø PVC Conduit
ELEC. WATER HEATER OUTLET
ALL NON-CURRENT CARRYING METAL PARTS SHALL BE PROPERLY GROUNDED IN
ACCORDANCE WITH THE PHILIPPINE ELECTRICAL CODE. 6" X 6 " CFL SQUARE PINLIGHT 12 SPARE 1,000 230 4.35 1 20 AT, 2P CB USE: 2-3.5 sq. mm. THHN STR. WIRE 20 mm Ø PVC Conduit
(WHITE CASING) RANGE OUTLET
N
13 SPARE 1,000 230 4.35 1 20 AT, 2P CB USE: 2-3.5 sq. mm. THHN STR. WIRE 20 mm Ø PVC Conduit
7. ANY DISCREPANCY IN LOCATION AND RATINGS OF EQUIPMENT AND APPARATUS SHALL BE (WARM WHITE BULB)
VERIFIED WITH THE OWNER OR ANY OF HIS REPRESENTATIVES AND CHANGES SHALL BE MADE 14 SPARE USE: 2-3.5 sq. mm. THHN STR. WIRE 20 mm Ø PVC Conduit
ACU CONVENIENCE OUTLET 1,000 230 4.35 1 20 AT, 2P CB
ACCORDINGLY. 10 WATTS WALL LAMP

8. ALL MATERIALS TO BE USED AND THE EQUIPMENT TO BE INSTALLED SHALL BE BRAND NEW A
ND MUST BE OF THE APPROVED TYPE FOR THE PARTICULAR LOCATION AND PROPOSED 3 WATTS LED TRACK LIGHT

9.
INTENDED.

THE MOUNTING HEIGHTS OF WIRING DEVICES SHALL BE AS FOLLOWS:

25 WATTS RECESSED DROP LIGHT
SCHEDULE OF LOADS: MDP
A.) LIGHT SWITCHES - 1.40m ABOVE FLOOR FINISH.
TOTAL CONNECTED LOAD 21,150 91,96
B) CONVENIENCE OUTLETS - 0.30m ABOVE FLOOR FINISH.
C.) PANELBOARDS AND CABINETS - 1.80 m ABOVE FLOOR FINISH OR REQUIRED. FOR FEEDER LINE : SERVICE FEEDER : ENCLOSURE : NEMA I
21,150 VA + 25% (2,250) @ 80% D.F. USE 2 - 30.0 sq.mm THHN
I TOTAL= MOUNTING : SURFACE
230 V 1 - 8.0 sq.mm THW
MAIN : 90 AT, 2P, 230 V CIRCUIT BREAKER
I TOTAL= 75.52 AMPERES / 85 A in 32 mm Ø PVC
FROM PLDT
WEATHER HEAD CAP CONCRETE POLE
METALLIC BOX
MERALCO POWER SOURCE
230 Vac, 60Hz, 2P, 3wire

TTC2
L2 L3 L4 L5
EQUIPMENT METAL SCREWS
GROUNDING 2 - 38.0 Sq.mm THHN
1 - 8.0 Sq. mm. THW SERVICE ENTRANCE
CONDUCTOR SECOND FLOOR LINE
IN 40 mm Ø RSC 230 V, 1Ø,3W,60Hz
FACE PLATE
KW-HR METER TEL.
TTC1 KW-HR METER
PB
SWITCH SPLICING DETAIL MAIN CKT. BRKR.
MDP PP1 RSC
L1

NOT TO SCALE 100 AMPS.

100 A 90 A ELBOW USE: 2 -38.0 Sq.mm THHN
1ST FLOOR LINE
1Ø 1Ø
1 - 8.0 Sq. mm. THW
8.0 SQ. MM BCW
GROUND FLOOR LINE GROUND LINE IN 40 mm Ø RSC
E E 8.0 SQ. MM BCW
GROUND LINE
SAND & GRAVEL BEDDING
SAND & GRAVEL BEDDING
100 AT
2P, 230 V

2 - 30.0 Sq.mm THHN

MOUNTING HEIGHT 1 - 8.0 Sq. mm. THW
NOT TO SCALE IN 32 mm Ø PVC
DINING
CATV

RECEPTACLE
90 AT,2P,
CABLE NETWORK 230V,60HZ.
PROVIDER LIGHTING OUTLET (1ST. FLR.) LIGHTING OUTLET (1ST. FLR.)
15 AT,2P 15 AT,2P
FAMILY MASTER'S CONV.OUTLET (GRD. FLR.) CONV.OUTLET (2ND. FLR.)
BDRM.1 BDRM.2 AREA BEDROOM 20 AT,2P 20 AT,2P
CATV CATV CATV CATV CONV.OUTLET (2ND. FLR.) 2.0 HP ACU OUTLET - MASTER'S BC.RM.
20 AT,2P 30 AT,2P (2ND. FLR.)
1.5 HP ACU OUTLET - BED ROOM 1 1.5 HP ACU OUTLET - BED ROOM 2
TO OTHER SECOND FLOOR LINE (2ND FLR.)
RECEPTACLE
30 AT,2P 30 AT,2P (2ND FLR.)
ELECTRIC WATER HEATER -MASTER'S ELECTRIC WATER HEATER - COMMON
T&B (2ND. FLR.) 20 AT,2P 20 AT,2P T&B (1ST. FLR.)
RG6 CABLE IN RANGE OUTLET D. KITCHEN SPARE
20mm Ø uPVC (TYP.) 40 AT,2P 20 AT,2P
(1ST. FLR.)
CATV CATV SPARE SPARE
DINING LIVING 20 AT,2P 20 AT,2P
SB PB
AREA AREA
TO OTHER
RECEPTACLE CATV CATV

1ST FLOOR LINE

RECEPTACLE SPLICING DETAIL E

USE 1-3.5 sq.mm TW(G) 8.0 SQ. MM BCW
GROUND LINE
NOT TO SCALE
COORDINATE WITH CATV PROVIDER E

4282 RA. 9266 ( ART. 4, SEC. 33 )

OWNERSHIP OF PLANS, SPECIFICATION and
A 03820556 other CONTRACT DOCUMENTS.
Drawings and specifications and other contract
documents duly signed and sealed, as instruments of
TARLAC

E-01
service, are the intellectual property and documents of the
architect, whether the object for which they are made is
executed or not. It shall be unlawful for any person to
01/06/2021 duplicate or to make copies of the said document for use in
the repetition of and for other projects or buildings, whether
executed partly or in whole, without the written consent
246-526-661 of architect.