USB Fast Charging Module
USB Fast Charging Module
(DCP/QC2.0/QC3.0/FCP/AFC/SFCP/SCP) of SOC IC
1 characteristic
3 Introduction
• Synchronous switching buck converter
• Built-in power MOS IP6505 It is a step-down converter with integrated synchronous switch, support
• Input voltage range: 10.5V To 28V
hold 10 A kind of output fast charging protocol, suitable for car charger and fast charging
• Output voltage range: 3V To 12V , According to the fast charge agreement
Sockets and intelligent power strips provide a complete solution.
auto-adjust
IP6505 Built-in power MOS , The input voltage range is 10.5V
• Output power: maximum 36W ( 3V@3A , 5V@3A ,
[email protected] , 12V@2A Wait) To 28V , The output voltage range is 3V To 12V , The maximum can provide
• Output voltage cable compensation function 24W The output power can be automatically based on the recognized fast charge protocol
• Output has CV/CC Characteristics (the output current is less than the setting Adjust the output voltage and current. Typical output voltage and current are:
Value, output CV Mode; the output current is greater than the set value,
3V@3 A , 5V@3A , 7V@3A , [email protected] , 12V@2A .
Output CC mode)
IP6505 The buck conversion efficiency is as high as 97.5% .
• Conversion efficiency up to 97.5%
IP6505 The output has CV/CC Characteristics, when the output current
• Soft start function
Less than the set value, output CV Mode, the output voltage is constant; when the output
• The switching frequency can be set by an external resistor
• Output fast charge The output current is greater than the set value, output CC Mode, the output voltage decreases.
• stand by DCP protocol IP6505 The output voltage has line compensation function, the output current increases
• Support Qualcomm QC2.0 with QC3.0 The output voltage will be increased accordingly to compensate for the impedance of the connecting
Road protection To automatically identify the fast charging protocol supported by the output terminal access device,
• Whole machine over-temperature protection Then automatically adjust the output voltage and current. IP6505 Supported Fast Charge Association
• ESD 4KV , DC withstand voltage 48V There are: DCP (Apple, Samsung and BC1.2 ),Qualcomm
protocol SFCP .
2 application
IP6505 There are multiple protection functions, with input overvoltage and undervoltage
• Car charger Protection, output over current, over voltage, under voltage, short circuit protection and other functio
4 Pin definition
SW VOUT
1 8
VIN
SW
7
2
IP6505
BST DP
3
ESOP8
6
FS DM
4 5
PIN List
Pin description
3 BST Bootstrap circuit pins, close to the chip BST Pin and LX A bootstrap capacitor is placed on
the pin to provide voltage for the gate drive of the upper tube
4 FS Frequency adjustment PIN , External resistor adjusts the frequency, can be suspended
7 VIN Input voltage pin, close to IC Need to place filter capacitor, recommended 22uF
9(EPAD) GND Power ground and heat dissipation ground, need to keep GND Good contact